Steamfast Nomad Handheld Travel Garment Steamer Manual

Steamfast Nomad Handheld Travel Garment Steamer

IMPORTANT SAFETY INSTRUCTIONS

This owner’s guide and any additional inserts are considered part of the product. They contain important information about safety, use, and disposal. Before using the product, please familiarize yourself with all operating and safety instructions. Please keep all documents for future reference and pass these documents on, together with the product, to any future owner. See steamfast.com to view, download, and print the most current version of this owner’s guide. When using your appliance, basic precautions should always be followed, including the following:

INTENDED USE: Use the appliance only for its intended use. This product is intended to be used indoors for garment steaming in the United States. This product is not intended for commercial or industrial use. The manufacturer assumes no responsibility for damage or injury due to unauthorized use or product modification. Failure to follow these directions will void the product warranty.

WARNING: Risk to Children and Impaired Persons. Supervision is required during the installation, operation, cleaning, and maintenance of this product by children 12 years of age and younger and anyone with reduced physical, sensory, or mental capabilities. Children should be supervised to ensure that they do not play with the appliance, its parts, or packaging material.

• Close supervision is required for any appliance used by or near children and pets. Do not leave the appliance unattended while it is connected.

WARNING: BURN HAZARD – To reduce the risk of burns or injury to persons, observe the following:

• Use caution when handling this steam unit. Burns can occur from touching hot metal or plastic parts, hot water, or steam. Do not touch the Steam Nozzle while the unit is in use. Use caution when you turn the unit upside-down – there may be hot water inside.
• Do not attempt to use the unit without properly filling the water tank. To avoid burns from escaping steam when refilling the tank: Press and hold the Steam Trigger to release all remaining steam pressure and always allow the unit to cool before refilling.
• To reduce the risk of contact with hot water emitted from steam vents, check the appliance before each use by holding it away from the body and operating the steam button. Do not operate the unit if steam vents are blocked.
• Do not point steam vents at people or pets, as serious injury or damage can occur.
• Do not iron or steam articles while wearing. Remove the article before using this appliance.

WARNING – To avoid damage to the unit or power cord, and to reduce risk of fire, electrical shock, and injury to persons, observe the following:

• Do not use the product if it has been dropped, if there are visible signs of damage, or if it is leaking. Shock, fire, or injury may occur.
• Do not allow the cord to touch hot surfaces. Let the appliance cool completely before putting it away. Do not wrap the cord around the unit; use the cord wrap provided for storage.
• Never yank the cord to disconnect from the outlet; instead, grasp the plug and pull to disconnect.
• This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electrical shock, this plug is intended to fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.
• If an extension cord is necessary, an 8A ampere-rated cord should be used. Cords rated for less amperage may overheat. Care should be taken to arrange the cord so that it cannot be pulled or tripped over.
• A loose fit between the wall outlet (receptacle) and the plug may cause overheating and distortion of the plug. Discontinue use of the product in this outlet. Contact a qualified electrician to replace loose or worn outlets.
• To reduce the risk of electric shock, do not immerse the appliance in water or other liquids.
• Always disconnect the appliance from the electrical outlet when filling with water or emptying, and when not in use.
• To reduce the likelihood of circuit overload, do not operate another high-wattage appliance on this same circuit.
• Only use distilled water to fill the unit. Do not use cleaning agents or other substances to fill the unit. Cleaning agents and other substances could result in injury or damage to the unit.
• Use caution when carrying the unit up stairs or over obstacles, or when using the unit on or near an uneven surface.
• Wrap the cord with the supplied cord wrap fastener when storing.
• Always allow the unit to cool (30 minutes for complete cooling) and empty the Water Tank before storing.

SERVICING WARNING – To reduce the risk of fire, electrical shock, and injury to persons, observe the following:

• Do not operate the appliance with a damaged cord, or if the appliance has been dropped or damaged. To reduce the risk of electric shock, do not disassemble or attempt to repair the appliance. Incorrect reassembly or repair could cause a risk of fire, electric shock, or injury to persons when the appliance is used. For information about available products and parts replacement, visit vornado.com/support or contact Vornado Consumer Service by phone (1-800-234-0604) or email [email protected].
• If the Steam Status Light does not illuminate when the unit is plugged in and the button is set to the “ON” position, the unit is not operating normally. Immediately disconnect the cord from the power supply, then refer to the troubleshooting guide on Page 9 of this manual for assistance.
• Clean your product regularly, only as instructed in this manual. Before cleaning, turn off the power to your product and unplug it. Do not use gasoline, thinners, solvents, ammonia, or other chemicals for cleaning. Refer to the cleaning instructions provided.

FEATURES

1. STEAM NOZZLE: Emits the flow of hot, penetrating steam.
2. HANDLE: Stays cool while providing maximum grip and comfort.
3. WATER TANK: Holds 5 oz. (148 ml) of water.
4. ON / OFF BUTTON
5. STEAM STATUS LIGHT: Illuminates red while the steamer is heating and will illuminate green when ready to use.
6. STEAM BUTTON: When the Steam Button is pressed, the unit will begin producing steam. NOTE: When the button is released, the unit will stop producing steam, but is still powered on.
7. AUTO SHUT-OFF (not shown): Release of the Steam Button starts a 10-minute timer so that the product automatically shuts off after 10 minutes unless the Steam Button is pressed again.

HOW TO USE

FILLING TANK WITH WATER

1. Turn OFF ( ) and unplug the unit from the power source.
2. Place the steamer on its side on a flat, heat-resistant, level surface. CAUTION: If the unit has been in use, allow it to cool (5 minutes minimum cooling before removing the Water Tank and adding water).
3. Remove the Water Tank by pulling the Water Tank downwards away from the unit; see Figure 1.
4. Remove the rubber cap from the top of the Water Tank and fill it with distilled water from a bottle or cup. Replace the rubber cap on top of the Water Tank. Do not overfill the water tank. NOTE: In order to extend the life of your unit and keep it functioning at its maximum potential, it is highly recommended that distilled water be used in the Water Tank. CAUTION: Burn Hazard. Using tap water could result in mineral buildup, which could block the steam outlets, causing this unit to spit or spurt hot water. Follow the cleaning instructions provided.
5. Replace the water tank by pushing firmly up into the unit. Always place the steamer securely on the side when not in use. Do not rest the steamer on other surfaces or attempt to stand the steamer on the Steam Nozzle or Base.

WARNING – Take care not to pinch your fingers or hand when replacing the water tank into unit.

FABRIC STEAMING

CAUTION: When steaming any material for the first time, it is recommended that you test on a small inconspicuous area before proceeding. Do not use on synthetic fabrics such as 100% nylon or polyester, or other steam-sensitive materials.

NOTE: Be sure the Water Tank has already been filled before following these steps.

1. Plug the power cord into a standard electrical outlet.
2. Power on and wait approximately 30 seconds until the Steam Status Light turns from red to green, indicating the unit is ready to use.
3. Direct the steam nozzle towards the fabric material you wish to steam. See below for additional tips and procedures.

WARNING: To reduce the risk of steam injury, always be sure that the Steam Nozzle is pointed in a safe direction (away from yourself, other people, and pets) when steaming.

STEAMING GARMENTS:

• Hang the garment from a clean, rust-free hanger.
• Direct the steam nozzle towards the bottom of the garment. Steam will rise along the inside and outside of the material, removing wrinkles. Slowly slide the Steam Nozzle upward from the bottom to the top of the garment.
• Direct the steam nozzle away from the garment and smooth material with your free hand.
• Repeat as necessary until the garment is fresh and wrinkle-free.

GENERAL STEAMING TIPS:

• For the most effective results, hold the Steam Nozzle within 1/2” of fabrics or press it directly against surfaces.
• Curtains and draperies can be steamed while still hanging.
• To remove wrinkles from towels, handkerchiefs, and napkins, drape them over a rod or towel rack and gently steam them.
• Heavier fabrics may require repeated steaming to achieve the desired results.
• To remove exceptionally stubborn wrinkles, steam both sides of the fabric.
• Be especially careful when steaming any delicate fabrics that may be damaged by heat or water spotting.
• When you are finished using your steamer, immediately turn off and unplug the power cord from the electrical outlet. Refer to STORAGE & CARE for proper storage and maintenance procedures.

STORAGE & CARE

Preparing your steamer for storage is quick and simple. When you have completed your tasks, follow the steps listed below.

1. Push the Power ON/OFF Button (Steam Status Light will turn off) and unplug the power cord.
2. Allow unit time to cool (at least 30 minutes).
3. Remove the water tank and drain any remaining water into a sink or tub to minimize potential mineral build-up. Replace the water tank when done.
4. Wrap the cord with the supplied “hook and loop” strap when storing. Do not wrap the cord around the product.
5. Store steamer in a cool, dry location.

MINERAL BUILD-UP

A common maintenance need for steam appliances is the removal of build-up caused by high mineral content in many municipal water supplies. This mineral build-up may cause the unit to spit water, which can result in burn injuries, and limit the effectiveness and reduce the life of your steamer.

The best way to minimize mineral build-up is to use distilled or de-mineralized water when using your steamer. In addition, it is recommended that the cleaning procedure below be followed at least once a month to remove any deposits that form. This will help to extend the life of your steamer and keep it functioning at its maximum potential.

TO REMOVE MINERAL BUILD-UP:

1. Follow STEPS 1-3 under the Proper Storage section above. However, do not replace the water tank at the end of STEP 3.
2. Fill Measuring Cup (not included) with 1 oz. (29.6 ml) distilled water and 1 oz. (29.6 ml) vinegar. Never add soap, detergent, or other cleaners, as this could cause damage to the product.
3. Slowly pour water-vinegar solution into the Water Tank through the Fill Hole, then replace the Water Tank Cap.
4. Plug in the power cord and press the ON/OFF Button to turn the unit on. Once heated, press the Steam Button to allow the unit to produce steam for 1 minute, then turn the unit off.
5. Allow the unit to sit for approximately 30 minutes, then press the ON/OFF Button to turn the unit on again and repeat Step 4 above. Repeat until the remainder of the Water Tank’s contents are steamed out.
6. Once the water tank is drained, turn unit off and refill the tank with 5 oz. (148 ml) of fresh distilled water. Allow the unit to steam until the Water Tank is empty. Repeat as necessary until the vinegar odor dissipates.
7. Turn the unit OFF, unplug the power cord, and store the steamer in a cool, dry location.

IMPORTANT: On average, it is recommended that you follow the mineral build-up removal procedure once per month (if the unit is used once every week). More frequent use may require following the procedure more often to keep your steamer operating at full potential. Do not exceed 1 hour of use without cleaning out mineral build-up. Failure to remove mineral build-up can result in clogged outlets and hot water spraying or spewing.

TROUBLESHOOTING

WARRANTY

Steamfast, a division of Vornado Air, LLC, warrants to the original consumer or purchaser that this Steamfast (“Product”) is free from defects in material or workmanship for a period of one (1) year from the date of acquisition. If any such defect is discovered within the warranty period, Vornado, at its discretion, will repair or replace the Product at no cost.

For warranty service: Call 1-800-711-6617 or email [email protected] to obtain a Return Authorization (“RA”). Please have or include your Product’s model number and serial number, as well as your name, address, city, state, Zip code, email, and phone number when contacting Vornado for warranty service. To file a contactless warranty claim, visit www.steamfast.com/contact.

This warranty does not apply to defects resulting from abuse of the Product, modification, alteration, mishandling, improper maintenance, commercial use, or repair or service of the Product by anyone other than Vornado; damages that occur in shipment or are attributed to acts of God. Improper product use, which includes using an external device that alters or converts the voltage or frequency of electricity, or shipping a Vornado product to a country not intended for use, will void all warranties. Any unauthorized product modification, repair by an unauthorized repair center, or use of non-approved replacement parts is not recommended, and any consequences will not be covered by support services or product warranties.

The product warranty will be honored only on models that are being used in the country intended. REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE CONSUMER. VORNADO SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF ANY EXPRESS OR IMPLIED WARRANTY ON THIS PRODUCT. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ON THIS PRODUCT IS LIMITED IN DURATION TO THE DURATION OF THIS WARRANTY.

Some states do not allow the exclusion or limitation of incidental or consequential damages, or allow limitations on how long an implied warranty lasts, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights, and you may have other rights that vary from state to state. The manufacturer assumes no responsibility for damage or injury caused by failure to follow these instructions, improper product use, or unauthorized product modifications. Any such actions will invalidate the product warranty.

All company names and product names are trademarks of their respective owners. © All rights reserved. All technical information, data, and instructions for the installation, connection, and operation contained in these instructions for use correspond to the latest available information at time of printing. The contents of this manual may differ slightly from the actual product. Observe any additional supplements. © 2025 Vornado Air, LLC. Andover, KS 67002, U.S. Specifications subject to change without notice. Steamfast® is a trademark owned by Vornado Air, LLC. Manufactured in China.

For More Manuals By Steamfast, Visit ManualsLibraryy.

Steamfast Nomad Handheld Travel Garment Steamer-FAQs