PureDailyCare NanoSteamer Clinical 10-in-1 Smart Ionic Facial Steamer
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, especially when children are present, basic safety precautions should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING
DANGER – To reduce the risk of electrocution:
- Always unplug this appliance immediately after using. Exception: This instruction is not required for a permanently installed wall-mounted hair dryer.
- Do not use while bathing.
- Do not place or store the appliance where it can fall or be pulled into a tub or sink.
- Do not place in or drop into water or other liquids.
- Do not reach for an appliance that has fallen into water. Unplug immediately. Exception: The instruction for a permanently installed wall-mounted hair dryer shall state, “If the hand unit falls into water, turn the unit off immediately. Do not reach into water.
WARNING & SAFETY
- Turn off & unplug the Nanosteamer Clinical before adding water to the water tank.
- Only use distilled water with the Nanosteamer Clinical.
- Do not immerse any part of the Nanosteamer Clinical in water.
- Avoid direct heat and damp surfaces when using the Nanosteamer Clinical.
- Only water-soluble essential oils can be added to the aromatherapy basket. Aromatherapy basket heats up while in use.
- Avoid direct contact.
- Prior to your first use of Nanosteamer Clinical on your skin, it is recommended to let one cycle of water run through and evaporate.
- While using the Nanosteamer Clinical, it is recommended to adjust the distance accordingly to allow proper ventilation between the steam and skin.
- Caution: STEAM IS HOT. If you experience pain or discomfort during your session, immediately stop and consult your physician.
- Do not shake or move the Nanosteamer Clinical during use.
- It is recommended to clean out the aromatherapy basket after each use.
- It is recommended to clean the outside of the Nanosteamer Clinical after each use by wiping with a damp towel, followed by a dry towel.
- Avoid using the Nanosteamer Clinical if you have sensitive skin or a medical condition affecting your skin. Keep out of reach of children and pets.
- Unplug the Nanosteamer after each use, before cleaning, and before maintenance.
NANOSTEAMER CLINICAL FUNCTIONS
- Hot steam helps to open pores, hydrate, and purify the skin.
- Cold steam function helps to tighten pores and refresh the skin, and lock in moisture.
- Smart steam function provides an anti-aging effect.
- Aromatherapy function allows essential oils to penetrate the skin more deeply.
STRUCTURE
MODE FUNCTIONS
Cleansing Mode: Makeup removal and deep cleanse. To be used prior to any other function.
Cold Steam: Tightens pores to lock in moisture.
Hot Steam: Relaxes pores and allows them to be receptive to moisture.
Smart Steam Mode: A combination of hot & cold alternating steam for maximum anti-aging benefits.
Hydration Mode: Hydrates dry skin and locks in moisture.
Oil-Control Mode: Locks in moisture while helping control oily skin types.
Cleansing Mode: Makeup removal and deep cleanse. To be used prior to any other function.
Cold Steam: Tightens pores to lock in moisture.
Hot Steam: Relaxes pores and allows them to be receptive to moisture.
Smart Steam Mode: A combination of hot & cold alternating steam for maximum anti-aging benefits.
Hydration Mode: Hydrates dry skin and locks in moisture.
Oil-Control Mode: Locks in moisture while helping control oily skin types.MODE USE
Cleansing Mode: 4 minutes of hot steam. The Nanosteamer Clinical will automatically shut off.
Cold Steam: Appropriately adjust the distance of the steam to the skin. Can be used for 60-70 minutes.- Hot Steam: Appropriately adjust the distance of the steam to the skin. Use hot steam for 2-3 minutes. After hot steam, follow with skin care and additional treatments.
Smart Steam Mode: Cold, 3 minutes. Hot, 3 minutes. The Nanosteamer Clinical will automatically shut off after 20 minutes.
Hydration Mode: Hot, 6 minutes. Cold, 1 minute. Hot, 3 minutes, Cold, 1 minute, Hot, 3 minutes, Cold, 1 minute. The Nanosteamer Clinical will automatically shut off.- Oil-Control Mode: Hot, 6 minutes. Cold, 3 minutes. Hot, 3 minutes, Cold, 2 minutes, Hot, 2 minutes, Cold, 1 minute. The Nanosteamer Clinical will automatically shut off.
HOW TO USE – AROMATHERAPY BASKET
- Remove aromatherapy basket & cover.
- Place drops of water-soluble essential oils in a basket.
- Place the aromatherapy basket back in the Nanosteamer Clinical.
- Place the cover back on the aromatherapy basket.
HOW TO USE – PREPARATION
- Fully remove any makeup, dirt, and oil with your face cleanser.
- Pop out the water tank by pressing the lid.
- Fill the water tank with 235ml of pure or distilled water.
- Remove the water tank cap by twisting counterclockwise.
- Place the water tank cap back on and turn the cap clockwise to close.
- Press the lid to place the water tank back in the Nanosteamer Clinical.
- Plug in the Nanosteamer Clinical.
HOW TO USE – COLD STEAM
- Press the M button to choose the appropriate mode on the LED display.
- After use, hold down the power button to turn off the Nanosteamer Clinical.
- Adequately adjust the distance between skin and steam.
- Unplug after use.
HOW TO USE – OTHER MODES
- Press the M button to choose the appropriate mode on the LED display.
- Choose the mode and time according to your preference.
- Adequately adjust the distance between skin and steam. 25cm (9-10 inches) is recommended.
- Unplug after use.
HOW TO USE – REMOVING WATER
- Wait three minutes before removing the water tank basket, allowing the temperature to decline.
- Drain water from the base of the Nanosteamer Clinical.
- Remove the aromatherapy basket and water tank.
- Wipe down the Nanosteamer Clinical with a dry towel.
HOW TO CLEAN THE NANOSTEAMER CLINICAL
- Unplug the Nanosteamer Clinical and drain out the water.
- Pour 1 cup of a 50/50 vinegar & water solution into the water tank.
- Turn on Hot Steam Mode for approximately 10 minutes.
- Hold down the power button to turn off the Nanosteamer Clinical.
- Allow Nanosteamer Clinical to cool for approximately 10 minutes and then drain.
- Pour distilled water back into the water tank to rinse out any residual vinegar smell.
- It is recommended to clean your steamer every week if used regularly.
TROUBLESHOOTING
TECHNICAL DATA
MAINTENANCE
- The water tank can only use distilled water. Do not add other liquids.
- Make sure your Nanosteamer Clinical is turned off and unplugged prior to adding water to the water tank.
- When using Hot Steam, allow adequate distance between the steam and face to avoid any injuries.
- When using the Nanosteamer Clinical, always exercise caution to prevent accidents.
- Do not submerge Nanosteamer Clinical in water.
- Please use the correct supply voltage of 120V/60Hz/.
- Do not add any chemical solvents or cleaners to the water tank.
- Keep the power cord at a distance from hot surfaces.
- If the power cord is damaged, it must be replaced by the designated maintenance staff or an equivalent professional.
- Do not disassemble or install the Nanosteamer Clinical without permission.
- If there is any problem with the electrical equipment, please contact [email protected].
- After using the Nanosteamer Clinical, unplug the power cord before cleaning.
- Do not use abrasive cleaners or corrosive liquids to clean the Nanosteamer Clinical.
For More Manuals By Pure Daily Care, Visit ManualsLibraryy.
PureDailyCare NanoSteamer Clinical 10-in-1 Smart Ionic Facial Steamer-FAQs
How do I use the Nano Ionic Facial Steamer?
Place the steamer on a flat surface, fill the water tank with clean distilled water, reattach it, and switch on the device. Wait about 30 seconds for steam to start, then let the mist cover your face for 5–10 minutes.
Should I wash my face before steaming?
Yes. Gently cleanse your skin before steaming to remove dirt, oil, and makeup. This helps open pores without trapping impurities.
What does a nano ionic facial steamer do?
It hydrates the skin, opens pores, removes impurities, softens blackheads, and improves absorption of skincare products. The nano steam particles penetrate deeper for better results than regular steam.
How long should I steam my face?
A session of 10–15 minutes is ideal. Avoid steaming longer to prevent dryness or irritation.
How often can I use a facial steamer?
Once or twice a week is recommended. Daily use is not advised as it can strip natural oils and cause sensitivity.
Is nano ionic steam safe for all skin types?
Yes. Nano Ionic Steam is gentle and suitable for most skin types, including sensitive and acne-prone skin.
Do I wash my face after steaming?
Yes. After steaming, rinse your face with lukewarm water or follow with a mask, toner, and moisturizer to lock in hydration.
What should I apply before and after steaming?
Before steaming: cleanse lightly.
After steaming: apply a clay mask, toner, or serum, followed by moisturizer to seal hydration.
Can steaming boost collagen production?
Yes. Steaming increases circulation, which stimulates collagen, improving firmness and elasticity over time.
Can steaming brighten skin?
Yes. Regular steaming promotes circulation, clears pores, and enhances glow by helping skincare products absorb better.