Dellonda DG65 Rattan Outdoor Dining-Bistro Table Installation Guide

Dellonda DG65 Rattan Outdoor Dining-Bistro Table

Important Information

Please read these instructions carefully. Note the safe operational requirements, warnings & cautions. Use the product correctly and with care for the purpose for which it is intended. Failure to do so may cause damage and/or personal injury and will invalidate the warranty. Keep these instructions safe for future use.

Refer to the instruction manual.

About the Product

Manufactured using premium quality PE weave rattan material. UV-treated, fade-resistant, and weatherproof design can be used outside all year round. Easy to clean 5mm clear tempered glass table top. It can be used as a side table, snack table, or bistro table. Disclaimer: Colours may slightly vary due to lighting conditions. Material: Polyurethane Rattan.

SPECIFICATION

• Model no: ……………………………………………………………………………….. DG65
• Table dimensions (Ø x H): ……………………………………………… Ø70 x 74cm
• Material: …………………………………………………………… Polyurethane Rattan

Safety Instructions

• Always read these instructions fully before assembling and using your furniture.
• WARNING! Keep all flame and heat sources away from this furniture.
• DO NOT use bleach, alkaline, or harsh detergents for cleaning. Soap and warm water are recommended.
• DO NOT use a high-pressure washer to clean this product.
• This product has a reasonable level of protection against UV degradation; however, as with any material, it will begin to fade and degrade after long periods of exposure to the sun.

Contents

Assembly

• Carefully turn the table top (A) onto its face and position the two legs (B) and bolt them in place using the M6 x 20mm bolts (E) and M6 steel washers (G).
• Offer up the two table base infill panels (C) into the table base legs (B), using the shown nut a bolt sequence to secure, pass a steel washer (G) onto the M6 x 35mm bolt (D) then pass this through the two tabs trapping a plastic washer (H) in between, then push on another M6 steel washer (G) and secure with an M6 nut (F), cover the bolt head by pushing the plastic bolt cap (I).
• Repeat this sequence for the other seven connecting positions.
• It may be useful to only tighten the bolts for all eight locations at the end of the assembly sequence.
• Turn the table assembly onto its feet and carefully lift into position the glass table top (J).

STORAGE

• Ensure that the table is clean and dry before being stored in a cool, dry, and well-ventilated location.
• Wipe down the table’s frame and legs and any areas that could have been exposed to mud and dirt.
• Store the table during long periods of non-use to prolong the usable life of all parts.

Environment Protection and Waste Protection and Electrical Equipment Regulations (WEEE)

Recycle unwanted packaging materials. When this product is no longer required or has reached the end of its useful life, please dispose of it in an environmentally friendly way. Drain any fluids (if applicable) into approved containers, according to local waste regulations. It is our policy to continually improve products, and we reserve the right to alter data, specifications, and parts without prior notice. No liability is accepted for incorrect use of this product.

Note: It is our policy to continually improve products, and a su, ch such reserve the right to alter data, specifications, and parts without prior notice.

Important: No Liability is accepted for incorrect use of this product. The

Warranty:The  Guarantee is 12 months from the purchase date, proof of which is required for any claim.

Dellonda Limited

Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR

01284 757575

[email protected]

www.dellonda.co.uk

For more manuals by Dellonda, visit ManualsLibraryy

Dellonda DG65 Rattan Outdoor Dining-Bistro Table- FAQs