Shenzhen YouXG 2BDHUCX3 LED Lamp Wireless Charger User Manual

Shenzhen YouXG 2BDHUCX3 LED Lamp Wireless Charger

Power

1. Watch Charging
2. Phone Charging
3. AirPods Charging
4. Aluminum alloy panel
5. RGB Ambient Lamp
6. Indicator Lights
7. Airpods Non-slip Mat
8. Touch Sensor Key
9. USB-C Power Socket
10. Bottom Label
11. Non-slip Mat
12. Heat Vent
13. Fast USB-C Cable
14. QC3.0 or PD Protocol Adaptor (18W or above)

Put phone to hold magnetically to charge

Put the iWatch to hold magnetically to charge

Put earbuds on the centre to charge

Charge 3 Apple Devices Simultaneously

Touch Key to Switch Colorful RGB Lamps

• Touch key to cyclically switch various RGB lamp modes to off mode
• Long touching can adjust the brightness of white and warm

Indicator Lights Instructions

APPLICABLE DEVICES 

1. Smart Phone: Apple: iPhone 12~15 full series, including other phones with MagSafe charging receiver(meet Qi standard).
2. Smart Watch: Apple: iWatch S2~58,5E 1~3, Ultra1/2.
3. TWS Earbuds: Apple: AirPods 2/3, AR Pods Pro 1/2. Include other earbuds with a wireless charging  receiver (meet Qi standard)

PRODUCT SPECIFICATION

Input 12Vv/2.5A Phone Output: 1SW/1I0W/7.5W/5W
Watch Output: 2.5W Earbuds Output: 3.0W
Input Socket: USB-C Conversion Rate(Phone): > 75%
Transmission Distance for Phone: 3~10mm
Product Size: 77.5 x 175 x 1693mm

PACKING LIST

• 4 IN 1 Wireless Charger x1
• User Manual x 1

WARNING

1. Avoid using the product in places that are wet, humid, or hot.
2. Avoid dropping the product from high places.
3. Do not disassemble the product by yourself.
4. Do not clean the product unless it’s powered off

FCC Warning

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for Compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class 8 digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates and uses can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help.

FCC RF exposure statement

The equipment complies with the FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated at a minimum distance of 20cm from your body to the radiator.

For More Blogs, Visit ManualsLibraryy.

Shenzhen YouXG 2BDHUCX3 LED Lamp Wireless Charger-FAQs