Breville Commercial Super Q Pro Blender User Manual

Breville Commercial Super Q Pro Blender

IMPORTANT SAFEGUARDS

READ ALL INSTRUCTIONS BEFORE USE AND SAVE FOR FUTURE REFERENCE

• Remove and discard all packaging materials and stickers before first use.
• To avoid a choking hazard for young children, remove and safely dispose of the protective cover fitted on the power plug.
• Do not use it in moving vehicles or boats, do not use it outdoors, and do not use it for anything other than its intended use. Misuse can cause injury.
• Close supervision is necessary when any appliance is used by or near children.
• This appliance can be used by persons with reduced physical, sensory, or mental capabilities or a lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and if they understand the hazards involved.
• Do not use the appliance near the edge of a countertop or table. Ensure the surface is level, clean, and free of water and other substances. Please be aware that vibration during use may cause the appliance to move.
• Do not use the appliance on or close to a hot gas or electric burner, or where it could touch a heated oven or surface.
• Do not allow the cord to hang over the edge of a countertop or to become knotted.
• To avoid electric shock, do not immerse the cord, plug, or motor base in water or other liquids.
• This appliance is equipped with a power cord having a grounding wire with a grounding plug. The appliance must be grounded using a properly grounded 3-hole outlet. In the event of an electrical short circuit, grounding reduces the risk of electrical shock.
• If the power outlet is a standard 2-prong wall outlet, it is your personal responsibility and obligation to have it replaced with a properly grounded 3-prong wall outlet. Do not, under any circumstances, cut or remove the third (ground) prong from the power cord or use an adapter.
• To avoid the possible hazard of the blender starting by itself due to inadvertent resetting of the overload protector on the motor, do not attach an external switching device (such as a timer) or connect the blender to a circuit that can regularly switch the blender on and off.
• Do not operate the appliance with a damaged cord or plug, or after the appliance malfunctions, or if dropped or damaged in any way. Immediately cease use of the appliance and visit www.BrevilleCommercial.com or call Breville | Commercial Consumer Support for examination, repair, or adjustment.

Components

A. Inner measuring cup

Removable for quick addition of ingredients.

B. High-performance lid

Withstands high-velocity tasks and is designed to vent steam and prevent splatter.

C. 68 fl oz (2L) BPA-Free* jug

Impact resistant, shatterproof proof and dishwasher safe.

D. Extra-wide, heavy-duty blade and bowl system

Designed with 4 powerful stainless steel blades contoured to the base of the jug for maximum cutting power and processing results, including liquid-free processing.

E. Heavy-duty metal coupling

For durable and long-lasting performance under demanding conditions.

F. Heavy-duty 1800W motor

High velocity power combined with high torque for outstanding results.

G. LCD indicator with timer

Counts down for pre-programmed settings and counts up for speed dial settings.

H. Durable base

I. 5 preset programs

Optimize the blender’s capabilities for crushing ice, smoothies, stir, boost, and A Bit More™.

J. Overload protection

Resettable thermal fuse for motor protection.

K. Manual speed control

Wide speed range from super slow stir up to high speed milling for precise control.

ACCESSORIES

L. Scraper

Designed to push food down from the walls or for easily removing ingredients after blending. Always use the scraper with the blender lid on (inner cap removed).

M. Tamper

Helps make frozen desserts, nut butters, and dips by pushing thick foods directly into the blades. Always use the tamper with the blender lid on (inner cap removed).

N. 68 fl oz (2L) BPA-Free* jug

Impact resistant, shatterproof proof and dishwasher safe.

COPOLYESTER MATERIAL

This blender jug is made with copolyester, which is a tough, BPA-Free polymer used to make household products that can stand up to extreme use and repeated dishwasher cleaning. Products made from copolyester are impact-resistant and shatter-resistant, and stay clear and durable even after hundreds of cycles in the dishwasher.

Breville | Commercial makes its BPA-Free claim for this product based on independent laboratory testing performed for all the food contact plastic materials of the product per EU Commission Regulation No 10/2011. BPA-free material is used in all parts that come into contact with food.

Functions

GETTING STARTED

Ready mode

Press the ON | OFF button to power the unit to READY mode.

Sleep

After 2 minutes of inactivity, the LCD powers off and the ON | OFF button flashes red. After 5 minutes of inactivity, the blender turns the power OFF. Press the ON | OFF button to reactivate the blender.

VESSELS

This unit features two blending vessels. The blender base automatically detects the vessel and adjusts blending times in pre-set programs to optimize food results.

68-ounce Jug

The jug is recommended for big volumes up to 68 ounces and can be used with all pre-set programs.

PAUSE / CANCEL

• For Manual Blending: First press pauses the selected speed. The second press cancels the selected speed. Turn the Dial to start blending again.
• For Program Blending: First press pauses the selected program. The second press cancels the selected program. Press the program button to start the program again.

MANUAL OPERATION

Speed Control Dial

Turn the Speed Control Dial clockwise to select one of 12 speed settings from a slow STIR through to a very fast MILL. To stop blending, turn the Speed Control Dial counterclockwise back to READY. The blender is programmed to allow manual speeds to run for a total of 6 minutes (68-ounce jug).

WARNING: Never blend boiling liquids. Allow the temperature of the ingredients to cool down to room temperature before placing them into the blender jug.

PRESET PROGRAMS

PULSE | ICE CRUSH

A program of continuous pulsing designed to chop food into an even consistency or crush ice cubes.

SMOOTHIE

For dairy-based smoothies. A combination of speeds and pulses designed to combine and aerate ingredients into a smooth and creamy texture.

STIR

This program bypasses the intermittent start/stop feature of the low-speed manual blending. It is designed for constant low-speed blending when making emulsifications or working with low volumes of liquid.

BOOST

A one-touch program to reach maximum speed quickly and blend the contents to a fine consistency. Use the tamper for best results.

A BIT MORE™

The A BIT MORE™ program is designed to produce a slightly finer texture across chunky mixtures and fine blends or to incorporate seasoning after tasting without over-blending.

TIMER

A precision speed control dial allows the user to set the perfect blending speed in conjunction with a built-in 6-minute timer that will auto-stop the blend.

CLEAN

Use to remove most of the ingredients from the blender walls and blades. Add 4 cups of warm, soapy water to the blender jug and press the CLEAN button. For harder-to-clean, sticky, or thick ingredients, add ½ teaspoon of liquid dish detergent for extra cleaning power. For best results, clean the blender jug this way immediately after use.

NOTE

If the blender is running and you press a different preset button, it will switch to that program without stopping. If a program is running and you press the same program button again, it will pause that program and the timer. To resume, press the same program button again.

Tips

• The inner measuring cap can be removed to add oils/liquids or other ingredients during blending. Extreme care must be taken as, depending on the mixture volume and speeds of operation, splashes can eject from the lid. We do not recommend removing the inner measuring cap when blending hot liquid.
• Do not exceed the maximum mark when adding foods and liquids into the blender.
• Run the blender only for the appropriate amount of time required. Do not overblend ingredients.
• Use the PULSE | ICE CRUSH button when food is too thick or coarse to circulate within the blender jug.
• The scraper and tamper accessories can be used during blending by removing the inner measuring cap. Always make sure the main lid stays firmly in place.
• Ingredients may stick to the sides of the blender jug. To push food back onto the blades with the main lid on (inner cap removed), use the tamper provided to scrape down the sides of the jug and continue blending.
  • If any moisture or liquid spills on top of the motor base during blending, turn the blender off and unplug it from the outlet. Remove the blender jug and wipe the motor base immediately with a dry cloth or paper towel.
• The optimum amount of ice cubes that the blender can process in the jug is 8 ounces (225g). That’s approximately 10 ice cubes.
• When the blender has been running for 6 minutes in manual mode with the jug, it will automatically turn off. This is a safety feature to protect the motor.
• Thicker mixtures puree more efficiently if the jug is ¼ to ½ full.
• Do not use metal utensils, as they may damage the blades or blender jug.
• Dates and other dried fruits may vary in hardness and moisture content. If adding dried fruits to smoothies, use the tamper for the first 15–20 seconds of the SMOOTHIE setting.
• To make nut milks, add 1–2 cups of raw or soaked/drained nuts. Add 3–4 cups of purified water and process on MILL for 1 minute. Strain through a nut milk bag or muslin/cheesecloth over a large bowl or jug. Close the bag and squeeze the pulp in the bag to extract as much milk as you can.
• To soak or not to soak nuts? This is a personal preference, and you can make nut milks with unsoaked or soaked almonds. Almonds are a great source of protein; however, they contain a naturally occurring compound that may prevent our enzymes from digesting the nuts effectively. Try soaking nuts overnight to help break down the compound. Always rinse and drain soaked nuts before use.
• Roasting nuts to make nut butter allows their natural oils to be released during blending and enriches the flavor. Some nuts, such as almonds and hazelnuts, have a lower oil content. Add rice bran, macadamia, or coconut oil when blending, if needed.
• Freshly milled whole grain flour does not keep as long as commercial flours. This is because the inner layers of the grain contain rich oils, which can become rancid over time with exposure to heat and moisture. Always store your flour in an airtight container in a cool, dry place. Flour can be stored in the refrigerator or freezer in warm/humid climates.
• Corn, soy beans, and some other dried legumes and grains vary in their moisture content and may not circulate properly during milling. Use the scraper or tamper during milling to assist with circulation.
• To remove any food that cannot easily be scraped out from under the blades, replace the lid and turn the blender back on high speed for 4–5 seconds to spin foods out from under the blades.

Care & Cleaning

Vessels and lids

To keep your jug clean and avoid food drying on the blades, vessels, and lids, follow the steps below as soon as possible after use:

• Rinse most of the ingredients off the vessels and lids.

68-ounce jug

• Add 4 cups (around 1L) of warm water and press the CLEAN button. If thick or sticky ingredients require extra cleaning power, add a few drops of dish liquid detergent.
• Rinse the jug and lid again and wash separately in warm soapy water with a soft cloth or bottle brush.

WARNING: Oils in the citrus rind can damage the material of the jug if left to sit on the jug for too long. Always clean your blender jug immediately after processing citrus rind.

Sanitizing

The recommended sanitizing solution is 1½ tsp (7.5mL) of household bleach in 2 quarts (2L) of clean, cool water, mixed according to the recommended instructions on the bleach container.

To sanitize, follow the steps below:

1. After performing the auto clean cycle as per the instructions above, add half of the recommended sanitizing solution (1 quart/1L) to the jug. Secure the lid and inner lid and press CLEAN to run a sanitizing clean cycle.
2. Allow to stand for 1 minute, then empty the solution.
3. To sanitize all the lids, scraper, and tamper, soak them in 1 quart (1L) of the sanitizing solution mixture for 2 minutes.
4. Place the empty jug and lid back on the blender base and run on manual speed MIX for 10–20 seconds to remove any excess moisture from the blade area.
5. Do not rinse after sanitizing. Allow to air dry before storage. Rinse with clean water before next use.

Motor base

To clean the motor base, wipe with a soft, damp cloth, then dry thoroughly. Wipe any excess food particles from the power cord.

Cleaning agents

Do not use abrasive scouring pads or cleaners on either the motor base or the jug, as they may scratch the surface. Use only warm, soapy water with a soft cloth.

Dishwasher

The blender jug, tamper, scraper, and all lids can be washed in the dishwasher on a standard wash cycle. The jug can be placed on the bottom shelf, and all lids should be washed on the top shelf only.

Stubborn food stains and odors

Strong-smelling foods such as garlic, fish, and some vegetables, such as carrots, may leave an odor or stain on the blender jug and lids. To remove, soak the blender jug and lids for 5 minutes in warm soapy water. Then wash with a mild detergent and warm water, rinse well, and dry thoroughly. Store the jug with the lid off.

Storage

Store your blender upright with the blender jug assembled on the motor base or beside it. Do not place anything on top. To allow air to circulate, keep the lid off.

Dry milling

Please note that milling hard ingredients like spices, nuts, sugar, coffee, grains, etc., will cause scratching and clouding of the inside surfaces of the jug. This is a cosmetic result from milling these kinds of ingredients and does not affect the performance of the jug.

Troubleshooting

For More Manuals By Breville, Visit ManualsLibraryy.