Dartwood Dual-Shot Blaster User Guide

Dartwood Dual-Shot Blaster

Safety Precaution

• CAUTION: Risk of fire and burns. Do not open, crush, heat above 45˚C, or incinerate. Follow the manufacturer’s instructions.
• Store items in a cool, dry place. Do not submerge the battery or device in water.
• Do not eat. Keep away from pets.
• Do not freeze or modify rounds.
• Do not modify blaster. Do not disassemble the device or battery.
• Do not leave unattended when charging the device.
• When shooting the gel shots, make sure that there are no foam darts already loaded in the gun.
• When shooting the foam darts, make sure there are no gel shots in the gel shot bottle.
• Impact from rounds may cause temporary marks on the skin.

In the Box

1 x dual-shot blaster

1 x rechargeable battery pack

1 x USB power cord

1 x safety goggles

1 x gel-shot-bottle connector

1 x gel-shot bottle

10 x suction cup soft bullet

1 x baggie of gel-shot bullets

Introduction to Parts

1. bullet bottle
2. gel-shot-bottle connector
3. power switch
4. trigger
5. battery compartment
6. lights
7. nozzle

How to Charge

1. Connect the USB cable to the battery pack.
2. Connect the USB to a USB power source, such as a wall plug or a laptop.
3. When the battery pack is properly connected and the battery pack is charging, the USB connector’s indicator light will go on. Once fully charged, the light will go off. Charging time is about 1.5 to 2 hours.
4. The battery pack will become warm when charging, which is normal.
5. Only use the original USB charging cable for charging.
6. When not using Dual-Shot Blaster, turn off the power switch to prevent energy drain and battery damage

Growing the gel-shot bullets

1. Pour a small amount of the dry gel-shot bullets into a container.
2. Gel shot expansion times vary according to water temperature.
3. If you use cold water, please soak the gel shots for about 3 hours.
4. When using water that is 122° F (50° C), it will take about one hour for the gel shots to absorb water and grow.

Installing the Battery

1. Unscrew and open the battery cover in the Dual-Shot Blaster’s handle.
2. Connect the battery to the cable inside the Dual-Shot Blaster handle.
3. Fit the battery into the handle/battery compartment.
4. Close the battery-handle latch and twist the screw to lock

Installing the gel-shot bottle

1. Fit the bottle mount to the top of the Dual-Shot Blaster and making sure the holes align properly
2. Fill the gel-shot bottle with the full-sized gel shots, and pour out any excess water from the bottle to avoid damaging the Dual-Shot Blaster.
3. Turn the Dual-Shot Blaster upside down and twist the gel-shot bottle to tighten it into the bottle mount.

How to shoot with the Dual-Shot Blaster

1. Press the power switch.
2. Pull the trigger once to fire a test shot.
3. Continuously pull the trigger to fire repeatedly

How to shoot the foam darts

1. Load the foam darts from the front, one at a time.
2. Pull the trigger once to shoot.

Troubleshooting

FOR MORE MANUALS BY DARTWOOD, VISIT MANUALSLIBRARYY

Dartwood Dual-Shot Blaster-FAQs