JJ Cole bundleme Infant Baby Car Seat
INSTRUCTIONS FOR USE
Recommended installation:
CAR SEATS
- remove the back harness panel.
STROLLERS
- keep the back harness panel in place.
Place the Bundleme® in a car seat or stroller. Fasten the elastic strap around the back of the car seat or stroller. Be sure to install a strap under any attached canopies. Do not adjust the elastic strap too tightly – there should not be a gap between the back of the bundleme and the car seat or stroller.
If your car seat has built-in head support, you may place the Bundleme (with back harness panel removed) around the head support. This may not be possible in all car seats.
Unzip sides and fold down the top of the Bundleme.
CAR SEATS
WITHOUT BACK HARNESS PANEL: Place Bundleme so the top of the back harness panel hole is even with the shoulder straps on your car seat or stroller.
illustration shows Bundleme® in car seat, top folded down
STROLLERS
WITH BACK HARNESS PANEL: Look at the back harness panel and locate the slots closest to the shoulder safety straps on your car seat or stroller.
illustration shows Bundleme® in stroller, top folded down
CAR SEATS & STROLLERS
Adjust Bundleme higher or lower as needed to ensure proper alignment.
CAR SEATS
WITHOUT BACK HARNESS PANEL:
Pull the shoulder straps through the back harness panel hole. Pull the bottom buckle through whichever bottom slot is compatible to your car seat or stroller. For smaller infants, the bottom buckle may come
through the back harness panel hole.
Illustration shows Bundleme® in car seat, top folded down
STROLLERS
WITH BACK HARNESS PANEL: Undo the fasteners on either side of the panel and pull the shoulder straps through the slots. Refasten the panel securely around the straps. Pull the bottom buckle through whichever bottom slot is compatible to your car seat or stroller.
illustration shows Bundleme® in stroller, top folded down
Now that the Bundleme is installed at the correct height, attach the top elastic strap around the back elastic strap to keep bundleme in place. Do not attach so tightly that the Bundleme is pulled out of place. If the elastic straps do not fit around your car seat or stroller, you may fasten them securely to each other and place them behind the bundleme. Do not place them within reach of the child.
Place child in seat as usual, ensuring no gaps between the back of bundleme and car seat or stroller, and the safety straps are positioned correctly. Fasten safety harness according to manufacturer instructions. Zip up and go!
For more manuals by JJ Cole, visit ManualsLibraryy
JJ Cole bundleme Infant Baby Car Seat-FAQs