Tiksounds S20 Smart Wireless Earbuds
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
FCC Statement: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Before Use
- Remove the protective film before charging.
- Fully charge the earbuds and charging case.
- Choose the right angle and ear tips.
Connect
- Take out the earbuds (Earbuds auto power on)
- After opening the phone Bluetooth, Click the <S20> to Pairing
RESET
If earbuds have any connection or function problems, please reset the earbuds
- Delete the BT pairing information on the phone.
- Take the earbuds into the charging case to charge.
- Take out the earbuds and wait for 20 seconds.
(If the above operation does not work, please try again)
Operation
- X1: Click Once
- X2: Click 2 times
- 2S： Press and hold for 2 seconds
Battery Indicator
For more manuals by Tiksounds, visit ManualsLibraryy
Tiksounds S20 Smart Wireless Earbuds-FAQs
How can I tell when my wireless earbuds are fully charged?
Your earbuds are fully charged when the green light on the charging port stops blinking.
Why are my wireless earbuds not pairing with each other?
1. Ensure both earbuds have sufficient charge, as uneven battery levels can cause connectivity issues.
2. If the issue persists, reset the earbuds following the manufacturer’s instructions.
How do I manually connect my earbuds to a device?
Turn off the earbuds, then press and hold the power button for about 10 seconds to enter pairing mode. Open your device’s Bluetooth settings, find your earbuds in the list, and select them to pair.
Do earbuds stop charging once they are fully charged?
Yes, once fully charged, the charging case stops supplying power, preventing overcharging.
How can I check the battery level of my earbuds case?
The charging case has a status light inside. When you open the case or place the earbuds inside, the light will blink white for about 5 seconds before displaying the battery status.
Can I charge my earbuds without the case?
Yes, if your earbuds have a USB-C or micro-USB port, you can charge them directly using a compatible USB cable.
How do I reset my S20 earbuds?
Place both earbuds in the charging case, close the lid, and wait for at least seven seconds. Then, remove them, and they will restart and reconnect automatically.
How do I manually turn on my earbuds?
Press and hold the power button on the earbuds for a few seconds until they power on.