
Tribit Stormbox Lava Bluetooth Speaker

To Charging The Speaker

- When the battery is lower than 20%, the red light blinks.
- When charging, the red light is always on.
- When fully charged(about 5 hours ), the red light turns off.
Note: When charging, please keep the charging port and charging cable completely dry.
To Charge Other Devices

Use the speaker’s USB-A port to connect and charge other devices.
The speaker stops charging other devices when the battery level drops below 20%.
Power On/OfPressress the power button once to turn on/off the speaker.
When there is no audio input or any operation, the speaker will automatically turn off after 15 minutes.
When the speaker cannot work normally due to unknown reasonslong-presss the power button for 70 seconds to achieve a forced shutdown and then restart the speaker.
Pairing

- Short pressss the Bluetooth button once to enter pairing mode.
- Long-press the Bluetooth button 2S to disconnect the Bluetooth connection.
- The speaker can be connected to up to two Bluetooth devices at the same time.
Note: If both Bluetooth and the audio cable are connected, you can switch between them by pressing the Bluetooth button twice quickly.
Controls

- x1: Press once
- x2: Press twice
- x3: Press three times
- 2s: Press and hold for 2 seconds
- Reset: Press and hold the +- button at the same time for 5s
Stereo Mode

- First, connect Speaker A to your phone’s Bluetooth, then press the TWS button.
- Make sure speaker B is not connected to any device, then press the TWS button.
- Both speakers play sound at the same time, indicating that TWS is successful; speaker A is the left channel,eand speaker B is the right channel.
Long-press any speaker’s TWS button for 2 seconds to exit TWS.
Party Mode

- Fi st connect the host speaker A to your phone’s Bluetooth, then short-press the TWS button 2 times.
- Make sure the other speakers are not connected to any device, then short-press the TWS button 2times.
- Other speakers broadcast a voice to indicate that they have successfully joined the group. Up to 700+ speakers can be connected at the same time.
Long-press any speaker’s TWS button for 2 seconds to exit the group.
TRIBIT APP

Download the TRIBIT app to adjust the EO settings, upgrade the firmware and explore more features.
Safety Precautions
- Tighten the silicone plug at the charging port to avoid water ingress and damage.
- When charging, please keep the charging port and charging cable completely dry.
- Do not throw or place the product in a place where it can be easily dropped to avoid damage to the product due to dropping.
- Do not disassemble, repair or modify the product.
- The product has a built-in lithium battery. Please do not dispose of it or put it in a fire or an overheating environment to avoid danger.
- Consumers who charge with a power adapter should purchase a power adapter that meets the requirements of local standards.
- The warranty period is 12 months.
Specifications
- Bluetooth Version: V5.4
- Output Power: BDW
- Bluetooth Protocol: A2DP, AVRCP, HFP, HSP
- Frequency Response Range: 43Hz-20KHz
- Frequency Band Range: 2402-2480MHz
- Maximum Transmission Power: ≤6dBm
- Battery: 43.2Wh
- Play Time: 24 Hours(At 50% volume with XBass Off)
- Charging Time: About 5 Hours with 15W input
- Waterproofing Grade: IP67
- Size: 370mm X 747mm X 152mm
- Weight: 2300g
FCC Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 75 of the FCC Rules. These mits are designed to provide reasonable protectioagainst harmful interferencee in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
IC CautIon
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
- This device may not cause interference, and
- This device must accept any interference, including interference that may cause undesired operation of the device.
The power delivered by the charger must be between min 2 Watts required by the radio eqequipmentand max 15 Watts to achieve the maximum charging speed.
Statements of Compliance
- Product Model: BTS38, TS-BTS20, BTS65, BTS25S, BTS12, BTS32, BTS31, BTS52, BTS10, BTS1 3, BTH92SC, BTH99, BTH95, BTS33, BTS56, BTS51
- Date Code: 20240101
- Name and Address of manufacturer: Thousandshores DeutschlanGmbH, Bredowstrasse 1e1e 17, Hamburg 22113, DE
- Name and Address of Authorised Representative: APEX CE SPECIALISTS LIMITED, 89 Princess Street, Manchester, M14HT, UK
The statement of compliance is prepared by or on behalf of the manufacturer of the product.
In the opinion of the manufacturer, they have complied with either-(i)the applicable security requirements in Schedule 1 of SI 2023 No. 1007
Provision 5.1-1 of ETSI EN 303 645 & provision 5_1-2 of ETSI EN 303 645;
Provision 5.2-1 of ETSI EN 303 645;
Provision 5.3-13 of ETSI EN 303 645.
The defined support period for the product: 20260101
For more manuals by Tribit, visit ManualsLibraryy
Tribit Stormbox Lava Bluetooth Speaker- FAQs
How do I turn on the Tribit StormBox Lava speaker?
Press and hold the Power button until the LED indicator lights up. The speaker will automatically enter Bluetooth mode if no device is connected.
How do I put the Tribit StormBox Lava in pairing mode?
When powered on, press the Bluetooth button once. The LED will start flashing, indicating the speaker is ready to pair.
How do I pair the speaker with my phone?
Enable Bluetooth on your phone, look for “Tribit StormBox Lava” under available devices, and tap to connect. The LED will turn solid when pairing is successful.
How do I know if my Tribit speaker is charging?
A red light appears while charging. When fully charged, the light turns blue or turns off depending on the model.
How do I know when the Tribit StormBox Lava is fully charged?
The LED indicator will change from red to blue, or stop glowing to signal a full charge.
How long does it take to fully charge the Tribit StormBox Lava?
On average, it takes around 4 hours to reach a full charge.
How long does the battery last on the Tribit StormBox Lava?
Battery life varies with volume, but typically lasts up to 30 hours at 50% volume with extra features disabled.
Should I keep my Tribit speaker plugged in all the time?
It’s safe for short periods, but keeping any device plugged in constantly may reduce long-term battery health.
How do I reset the Tribit StormBox Lava speaker?
Press and hold Power + Volume Down for about 5–10 seconds until the LED blinks, indicating a factory reset.
