Bosch Nexxt 500 Plus Series Washer User Manual

Bosch Nexxt 500 Plus Series Washer

IMPORTANT SAFETY INSTRUCTIONS

1. BOSCH washers are provided with an Operating, Care, and Installation Instructions Manual. Read and understand all instructions before using the washing machine.
2. Do not wash articles that have been previously cleaned, washed, soaked, or spotted with gasoline, dry cleaning solvents, or  other flammable or explosive substances, as they give off vapors
   that could ignite or explode.
3. Do not add gasoline, dry cleaning solvents, or other flammable or explosive substances to the wash water. These substances give off vapors that could ignite or explode.
4. Under certain conditions, hydrogen gas may be produced in a hot water system that has not been used for 2 weeks or more.
   HYDROGEN GAS IS EXPLOSIVE. If the hot water system has not been used for this length of time, turn on all hot water faucets and let the water flow out of each faucet for several minutes before using the washing machine. This will release any accumulated hydrogen gas. As the gas is flammable, do not smoke or use an open flame while carrying out this procedure.
5. Before the appliance is removed from service or discarded, remove the door and the power cord/plug.
6. Do not reach into the appliance if the wash drum is moving.
7. Do not install or store this appliance where it will be exposed
   to the weather.
8. Do not tamper with the controls.
9. Do not repair or replace any part of the appliance or attempt any service unless specifically recommended in the user
   maintenance instructions or in published user repair instructions that you understand and have the skills to carry out.
10. Always unplug the washing machine from the power supply
    before attempting any service. Disconnect the power cord by
    grasping the plug, not the cord.
11. To reduce the risk of fire, clothes, cleaning rags, mop heads, ds, and the like, which have been soiled with any flammable substance, such as vegetable oil, cooking oil, petroleum-based oils or distillates, waxes, fats, etc., must be kept away from any source of ignition, including a clothes dryer. These items may contain flammable substances that, even after washing, may smoke or catch fire.
12. Do not machine wash fiberglass materials (such as curtains and
    window coverings that use fiberglass materials). Small particles may remain in the ‘washing machine and stick to
    fabrics in subsequent wash loads, causing skin irritation.
13. When children become old enough to operate the appliance, it
    is the legal responsibility of the parents or legal guardians to
    ensure that they are instructed in safe practices by a qualified
    persons.
14. Do not allow children to play on or with the appliance. Close
    Supervision of children is necessary when the appliance is
    used near children.
15. Keep pets away from the washing machine.
16. Do not insert/pull out the power plug with wet hands.
17. Do not touch the door when washing at high temperatures.
18. Use caution when draining hot water.
19. Do not climb onto the washing machine and/or lean on the open door.
20. Do not sit or stand on the top of the washing machine.

INSTALLATION INSTRUCTION

Information concerning waste disposal

Disposing of the packaging

The shipping package has protected your new appliance on its way to your home. All packaging materials are non-polluting and recyclable. Please contribute to a better environment by disposing of packaging materials in an environmentally friendly manner. Please ask your dealer or local authority about the best means of disposal.

Factory-supplied Equipment

There is a packet of accessory parts supplied with your washer. Check that all the accessory parts supplied for your model are there. If any parts are missing, contact your dealer immediately.

The drum contains:

1. Water drain hose
2. User manual literature pack

The literature pack contents include:

1. Elbow
2. Accessory parts bag

The accessory parts bag contains:

1. Covers to be placed over the holes for the transport bolts (after
   removing the transport bolts during washer installation).
2. Wrench for leveling.
3. Clamp for drain hose.

On the back of the washer:

• — hot and cold water connections
• — power cord with label warning to remove transportation bolts
• — two AQUASTOP® hoses (remove hoses from clips on back of washer for installation)

Useful tools

The following tools are helpful: 

1. Flat head screwdriver.
2. Socket wrench (1/2″ / 13 mm).
3. Closed wrench (1/2 / 13 mm).
4. Bubble Level.

Dimensions

• a27.0 inches (686 mm)
• b=b0.7 inches (780 mm)
• c = 37.0 inches (940 mm)
• d d.0 inches (407 mm)

Door opening angle 180 °. Approx. weight = 220 Lbs (100 kg)

Installation area

If the washing machine is to be installed on a weak wood floor, consider the following:

• Soft floor surfaces, such as carpets or surfaces with foam backing, are not suitable. If possible, place the washing machine in a corner of the room.
• Screw a water-resistant wooden board (at least 3/4” thick) to the floor.
• Secure the feet of the washing machine with holding brackets. Order the holding brackets (set) from Bosch Customer Service (WMZ 2200).
• Units are not designed to be stacked.
• Units are not designed for under-counter installation

Removing the transport bolts

• Loosen all four bolts before removing any of the bolts, all the
  ‘way from the unit.
• Remove the bottom two bolts before removing the TGP’s two bolts.
• Remove the bolts in the order shown in the diagram below.
  Loosen the bolts using the closed end of the 1/2” wrench provided. Loosen them until they can be removed freely.
• The recessed bottom bolts may be easier to remove using a 1/2” (13 mm) socket wrench.

• Completely remove all 4 transport bolt assemblies (bolt, spring, washer, and bushings). Pull the washer drum slightly forward to open the washer door and reduce pressure on the transport bolt assemblies. Slide each loosened transport bolt assembly out of its retaining slot, then pull it out through the round hole in the housing.
• If the bushings do not come out when removing the bolts, place the bolts back into the bushings and carefully try again. It is important to do this with the bolts; otherwise, the bushings will not come out properly.
• To store the bolts for future use, do not remove the bolts from the plastic bushings.

Storing the transport bolts

Always keep the transport bolts for future transportation of the appliance (such as when moving out).

• Store the transport bolts with the washer and bushing attached.

Water connection

Water supply

If in doubt, have the water connection installed by an authorized technician. The water supply hoses must not be:

• ~ Bent or flattened.
• — Modified or cut (integrity can no longer be guaranteed).

Observe the water pressure in the supply network:

• The water pressure should be between 20 and 120 psi. (1.87 and 8.3 bars) When the tap | is turned on and at least 2.2 U. S. gallons (8 liters) of water should be discharged per minute.
• A pressure regulator valve must be installed if the maximum water pressure is exceeded.

Supply Line Connection

C Cold water connection and
H Hot water connection (max. 140 °F / 60 °C)

• Plastic threads must only be tightened by hand when connecting the water supply hoses to the back of the unit. Do not remove the strainers from the water supply hoses.

• After connecting, turn on the water completely, and check that
  ‘Connection points are watertight.

Hose Extension

The AQUASTOP® hose may not fit in the space available at the wall faucet. A short extension hose (part no.645787 ) is available through customer service (see page 24).

AQUASTOP®

Upon leak or flood detection, a stop-valve system in the hose, and/or
a floating switch in the base, triggers machine cessation for virtual
containment (worst-case scenario with normal machine operation, 4 liters of water may escape. AQUASTOP® is an internal containment technology, and does not protect against outside forces, such as home plumbing problems, or damage caused to the machine’s hose (such as installation damage). The machine must be
level and turned “on” for proper functionality.

• The AQUASTOP® feature is not active and will not operate if the program selector is in the “Off” position.
• The washer must be level for correct AQUASTOP™ operation.

OPERATING INSTRUCTION

Pannel

Before Using For the First Time

The washing machine must be installed and connected properly (refer to Page 6

Using For the First Time
First washing cycle (without laundry). Your appliance was tested before leaving the factory. To ensure a fresh wash with your initial load of clothes, run the washer through a complete cycle, without clothes, in advance.

• Do not load any laundry.
• Turn on the water tap. |
• Open the flap of the detergent dispenser.
• Pour approx. 1 quart (1ften)of water into the detergent chamber, see Page 14.
• Pour 1-2 Tbsp. deteDetergento. Detergent chamber.
• Do not use special detergents for dlicates or wool (this will cause excessive sudsing).
• Close the flap of the detergent dispenser.
• Close the door.
• Set the program selector to Regular/Cotton Hot. The Star/Pause indicator light flashes red.
• Press the Start/Pause button. The program starts.
• ‘The indicator light is on (red). The display shows the run time of the program. ‘When the display shows “0:00”:
• Open the door.
• Turn the program selector to Off.

Preparing the laundry

• Empty all pockets.
• Brush off lint and dirt.
• Close zippers, button up duvets, and hooks.
• Remove curtain rings or tie them up in a net bag.
• Remove pins, buttons, buckles, and other hard objects to avoid
  scratching the washer interior.
• Remove non-washable trim and ornaments.
• Turn synthetic knitwear inside-out to avoid piling.
• Treat spots and stains.
• To prevent loss or damage to laundry and the machine, the following items should be washed in a mesh laundry
  bag:
• Baby socks (small items)
• Hosiery
• Belts
• Underwired bras (directly washed in the washer, the wire may come loose during washing and cause damage)

Programs and Functions

For optimum washing results, your washer offers several program groups and additional options. Basic programs include Regular/Cotton and Permanent press. Program selection is based in part on the laundry fabric type. Cycle times will vary depending on the cycle selected, temperature, and pressure of incoming water, water hardness, size of load, and type of fabrics. Special programs are custom-designed for special wash needs or specific types of fabric. Additional options may be selected by pressing one of the panel option buttons.

Maximum spin speeds of the programs
The indicator light “max spin speed” is lit red.

User Maintenance Instructions

Cleaning and Care

Cleaning the appliance housing and control panel, as required:

• Use hot soapy water or a mild, non-abrasive cleaning agent.
• Rub dry with a soft towel.

Cleaning the drum

• If rust spots have formed due to IVR debris (e.g., coins, paper clips, nails):
• Use a chlorine-free cleaning agent. Follow the manufacturer’s

instructions. Never use steel wool.

Cleaning the detergent dispenser

If residual detergents or additives have accumulated or if softener/bleach are not fully rinsed out:

• Open the flap of the detergent dispenser.

• Pull out the softener/bleach compartment in a vertical direction and remove it.
• Clean the detergent dispenser by inserting it under warm running water.

Troubleshooting of Minor Faults

If repairs are necessary, and you cannot eliminate the fear yourself with the aid of the following table:

• Turn the program selector to Off.
• Disconnect the washing machine from the power outlet.
• Turn off the water taps.
• Call Customer Service – (refer to Page 24).

FOR MORE MANUALS BY BOSCH, VISIT MANUALSLIBRARYY

Bosch Nexxt 500 Plus Series Washer-FAQs