Petwant PW-107 Stainless Steel Pet Water Fountain
Pet Fountain
Before we start: Care instructions
To keep providing fresh, clean water for your pet, remember these three simple tasks:
- Refill often. Keep the water level up. The pump is designed to work in at least one inch of water. The pump can fail if it runs dry
- Clean your pump and your fountain. Take your pump and fountain apart to clean with soap and water every two to four weeks. Be careful not to get soap in the filters, as it will not rinse out.
- Replace your filters. Replace the carbon filter every four weeks when you clean your fountain. Replace the foam filter every two months.
What you have：
Setup instructions
- Schematic diagram for pump installation
- Install the filter:
- Install the lid & flower
Use instructions
Place the fountain where your pet will use it. Fill the vessel with water, leaving a half-inch of space between the water and the rim. Make sure your hands, the cord, and the power adaptor are dry. Keep health and happiness flowing!
To extend product life, please clean the pump every 2 weeks.
- Remove the Pump Cover
- Remove the Impeller cap by placing your fingernail underneath the small lip located.
- Remove the Impeller and clean the parts with soap and warm water.
Cautions
- Be sure to shut down and disconnect the power supply for safety when the equipment is not in use.
- This product is for indoor use only.
- The power adapter and wire plug must not be flooded during cleaning.
- This product is not allowed to run without water (can be ignored for models with the function of automatically running without water).
- Please disconnect the power supply before maintaining and cleaning the machine.
For More Manuals By Petwant, Visit ManualsLibraryy.
Petwant PW-107 Stainless Steel Pet Water Fountain-FAQs
Q1. How do I clean a stainless steel pet water fountain?
A1. Wash the bowl and cone with a 50/50 mix of white vinegar and water to remove buildup or slime. For lighter cleaning, you can also place them in the dishwasher (top rack only).
Q2. How often should I replace the filter in my Petwant PW-107 fountain?
A2. The filter should be changed about every 30 days, but this may vary depending on how often your pet drinks and the number of pets using the fountain.
Q3. Can I wash the fountain filter instead of replacing it?
A3. Yes. Before use, rinse the carbon filter under warm water for about 30 seconds. However, rinsing does not extend its lifespan—it still needs regular replacement.
Q4. How often should I change the water in the fountain?
A4. It’s best to change the water at least once a week to keep it fresh and prevent bacteria or algae growth.
Q5. Are stainless steel pet fountains safe for pets?
A5. Yes. The Petwant PW-107 is made of 304 stainless steel, which is durable, scratch-resistant, and safer than plastic as it resists bacteria buildup.
Q6. How do I deep clean the fountain?
A6. Disassemble all parts (except the pump) and wash with warm water and mild soap. For stubborn stains or residue, soak parts in white vinegar and water for 30 minutes, then rinse thoroughly.
Q7. Can I use tap water in my pet fountain?
A7. Yes, but distilled or filtered water is recommended. Tap water may contain minerals that can cause buildup or stains over time.
Q8. Should I leave my pet fountain running all the time?
A8. It’s safe to leave it on, but monitor water levels to prevent the pump from running dry. If water loss is high due to evaporation, turning it off at night can help conserve water and protect the pump.