Dartwood Portable Electric Nail Drill
In the Box
1 x electric nail drill
1 x USB cable/switch
1 set of drill bits/filing bands
1 x pack of extra filing bands
Warning
- Keep away from heating sources while in use, such as portable heaters, radiators, stoves, open flames, etc.
- Keep away from dust, dirt, smoke, chemical/corrosive materials, and water.
- Make sure this device is cleaned and stored safely after use.
Setup
- Plug one end of the USB cable into the electric nail drill and plug the other end into a USB port.
- Select your preferred drill bit and push it firmly into the nail drill.
- Turn the nail drill on/off by flipping the switch on the USB cable (right for forward, left for reverse).
- Adjust the speed by turning the knob next to the switch.
- To remove, turn off the device and pull out the drill bit.
Filing Bands
- Select the filing drill bit and push it firmly into the nail drill.
- Select your preferred filing band (fine or coarse) and push it firmly over the top of the filing drill bit.
- To remove, turn off the device and pull off the filing band. Then pull out the drill bit.
Specifications
- Input: DC 5V 2A
- Output: DC 12V 1A
- Rated voltage: DC 5V 0.1A
- No-load speed: 16,000 – 20,000 RPM
- Load speed: 14,000 – 17,500 RPM
- Power supply: USB cable
- Product size: 4.75 x 0.8 in
- Product weight: 2.2 oz
- Cable length: 5 ft
FOR MORE MANUALS BY DARTWOOD, VISIT MANUALSLIBRARYY