HyperX Cloud Earbuds II
Overview
- A Left earbud
- B Right earbud
- C Mobile multifunction button
- D In-line microphone
- E 3.5mm plug
- F Interchangeable ear tips. (extra small, small, medium (preinstalled), large)
- G Carrying case
Fitting the HyperX Cloud Earbuds II to your ears
Changing ear tips
Using with Nintendo Switch™
Using with mobile device’
Requires 3.5mm headset jack with standard ClA connection or compatible 3.5mm adapter.
Questions or Setup issues?
Contact the HyperX Support Team or view the user manual at hyperx.com/support
WARNING: Permanent hearing damage can occur if a headset is used at high volumes for extended periods.
FCC Compliance and Advisory Statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, according to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used according to the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Any special accessories needed for compliance must be specified in the instruction manual.
Warning: A shielded-type power cord is required to meet FCC emission limits and also to prevent interference with the nearby radio and television reception. Only the supplied power cord must be used. Use only shielded cables to connect 1/0 devices to this equipment.
CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.
For more manuals by HyperX, visit ManualsLibraryy