Petwant PWS-105 Pet Water Fountain
Pet Fountain
Before we start: Care Instructions
In order to provide your pet with fresh and clean water continuously, please remember these three simple tasks:
- Refill often. Keep the water level. The pump is designed to work in water at least one inch deep. If the pump dries, it may malfunction.
- Clean your pump and your fountain. Take your pump and fountain apart to clean with soap and water every two to four weeks. Be careful not to get soap in the filters, as it will not rinse out.
- Replace your filters. Replace the carbon filter every four weeks when you clean your fountain. Replace the foam filter every two months.
What you have：
Setup Instructions
- Install the pump holder first, then put the pump into the sponge. Put the activated carbon filter in the filter housing and close it.
- Open the cover and put it back.
- Put back the cover to form a seal. Note: Make sure the pump is fixed in place in the tank.
- Insert the water faucet.
- Insert the water faucet.
- Connect the power adaptor.
Use Instructions
Place the fountain where your pet will use it. Fill the bowl with water, leaving a half-inch of space between the water and the rim. Make sure your hands, the cord, and the power adaptor are dry, then plug the fountain into an outlet. Keep health and happiness flowing!
Clean the pump and fountain every two weeks.
Take off the pump cover and rotor. Use the brush to clean the parts with water.
Cautions
- Be sure to shut down and disconnect the power supply for safety when the equipment is not in use.
- This product is for indoor use only.
- The power adapter and wire plug must not be flooded during cleaning.
- This product is not allowed to run without water (models with an automatic shutdown function without water can be ignored)
- Please disconnect the power supply before maintaining and cleaning the machine
For More Manuals By Petwant, Visit ManualsLibraryy.
Petwant PWS-105 Pet Water Fountain-FAQs
Q1. How do I set up the Petwant PWS-105 Pet Water Fountain?
Place the fountain on a flat surface, fill the tank with clean water, connect the filter, and plug it into a power source. Ensure the pump is fully submerged before switching it on.
Q2. How do I assemble the Petwant PWS-105 fountain after unboxing?
Insert the filter into its slot, attach the pump securely, and connect the water spout. Finally, lock the top cover in place and fill the reservoir with water.
Q3. How can I reset the Petwant PWS-105 if it is not working properly?
Unplug the fountain, press and hold the reset button (if available) for about 5 seconds until the light indicator blinks, then plug it back in. This restores factory settings.
Q4. Why is the light on my Petwant fountain flashing?
A flashing orange or red light usually means the water level is low or the fountain needs cleaning. Refill the tank or check if the filter and pump are properly installed.
Q5. How do I clean and maintain the Petwant PWS-105 fountain?
Disassemble the unit, wash all parts with mild soap and water, and rinse thoroughly. Clean the pump every 2 weeks and replace the filter every 3–4 weeks for best performance.
Q6. Does the Petwant PWS-105 require Wi-Fi to operate?
No, the fountain works without Wi-Fi. It is a plug-and-play system designed to provide a continuous flow of fresh water for your pet.
Q7. How do I reset the Wi-Fi if my fountain model supports smart features?
Use a paperclip to press and hold the Wi-Fi reset button for 3–5 seconds until the LED indicator flashes. Reconnect it through the app if your model supports app control.
Q8. What should I do if my Petwant fountain stops working?
Check if it’s plugged in, ensure the water tank is filled, and clean the pump. If the light still blinks red after cleaning, try a reset or replace the filter before contacting support.