Petwant PWS-109 2L Stainless Steel Pet Water Fountain
Pet Fountain
Before we start: Care Instructions
In order to provide your pet with fresh and clean water continuously, please remember these three simple tasks.
- Refill often. Keep the water level. The pump is designed to work in water at least one inch deep. If the pump dries, it may malfunction.
- Clean your pump and your fountain. Take your pump and fountain apart to clean with soap and water every two to four weeks. Be careful not to get soap in the filters, as it will not rinse out.
- Replace your filters. Replace the carbon filter every four weeks when you clean your fountain. Replace the foam filter every two months.
What you have：
Setup Instructions
- Install the pump holder first, then put the pump into the sponge. Press the pump to make the suction cup under the pump stick tightly.
- Put the activated carbon filter in the filter housing and close it.
- Open the cover and put it back.
- Put back the cover to form a seal.
- Connect the power adaptor.
Use Instructions
Place the fountain where your pet will use it. Fill the bowl with water, leaving a half inch of space between the water and the rim. Make sure your hands, the cord, and the power adaptor are dry, then plug the fountain into an outlet. Keep health and happiness flowing!
Clean the pump and fountain every two weeks.
Take off the pump cover and rotor. Use the brush to clean the parts with water.
Cautions
- Be sure to shut down and disconnect the power supply for safety when the equipment is not in use.
- This product is for indoor use only.
- The power adapter and wire plug must not be flooded during cleaning.
- This product is not allowed to run without water (models with an automatic shutdown function without water can be ignored)
- Please disconnect the power supply before maintaining and cleaning the machine.
For More Manuals By Petwant, Visit ManualsLibraryy.
Petwant PWS-109 2L Stainless Steel Pet Water Fountain-FAQs
How does the Petwant water fountain work?
It uses a motorized pump to circulate water continuously through a filter, keeping the water fresh, clean, and cool for your pet.
How do I clean the stainless steel fountain?
Wash the bowl and center cone with a 50/50 mix of white vinegar and water or mild soap. Both parts are top-rack dishwasher safe if not heavily soiled. Rinse thoroughly and reassemble.
Can I use citric acid to clean the fountain?
Yes. Mix 1 tablespoon of citric acid in warm water, apply to dirty areas, and rinse thoroughly. Citric acid is safe for stainless steel and helps remove stubborn residues.
How often should I clean the fountain?
Clean lightly once a week and perform a deep clean monthly, especially if you have hard water.
Do the filters need cleaning or replacement?
Rinse carbon filters under warm water for 30 seconds before use. Replace filters every 2–4 weeks for single pets, or more frequently if heavily used.
Can algae grow in a stainless steel fountain, and how do I prevent it?
Algae can grow in sunlight and warm conditions. Reduce sunlight exposure, change water daily, and clean regularly to prevent algae buildup.
Does the fountain need to be plugged in?
Yes, it requires electricity to run the pump. Ensure it’s near an outlet, and use safety measures to prevent pets from chewing cords.
What are the benefits of using a pet water fountain?
Fountains encourage pets to drink more water, keep it cleaner than a bowl, reduce bacteria and slime buildup, and provide continuously fresh, filtered water.