Petwant PWS-112 Pet Water Fountain
Pet Fountain
Before we start: Care Instructions
In order to provide your pet with fresh and clean water continuously, please remember these three simple tasks:
- Refill often. Keep the water level. The pump is designed to work in water at least one inch deep. If the pump dries, it may malfunction.
- Clean your pump and your fountain. Take your pump and fountain apart to clean with soap and water every two to four weeks. Be careful not to get soap in the filters, as it will not rinse out.
- Replace your filters. Replace the carbon filter every four weeks when you clean your fountain. Replace the foam filter every two months.
What you have:
Setup Instructions
Install the pump holder first, then put the pump into the sponge. Put the activated carbon filter in the filter housing and close it.
Soak the filter in a clean bowl for 5 minutes.
Notes:
- The filter must be fully soaked before the fountain is turned on; Otherwise, the water may not diffuse through the filter and cause overflow.
- Do not soak the filter in the fountain tank to avoid dust on the surface.
Open the cover and put it back.
Connect the power adaptor.
Use Instructions
Place the fountain where your pet will use it. Fill the bowl with water, leaving a half-inch of space between the water and the rim. Make sure your hands, the cord, and the power adaptor are dry, then plug the fountain into an outlet. Keep health and happiness flowing!
Clean the pump and fountain every two weeks.
Take off the pump cover and rotor. Use the brush to clean the parts with water.
Cautions
- Be sure to shut down and disconnect the power supply for safety when the equipment is not in use.
- This product is for indoor use only.
- The power adapter and wire plug must not be flooded during cleaning.
- This product is not allowed to run without water (models with an automatic shutdown function without water can be ignored).
- Please disconnect the power supply before maintaining and cleaning the machine.
For More Manuals By Petwant, Visit ManualsLibraryy.
Petwant PWS-112 Pet Water Fountain-FAQs
Q1. How does the Petwant PWS-112 fountain work?
It uses a circulating water pump to provide continuous filtered water, encouraging pets to drink more.
Q2. How often should I clean the water fountain?
For hygiene, clean the fountain and change the water at least once a week, or more frequently if multiple pets use it.
Q3. How do I replace the filter in the Petwant PWS-112?
Open the filter compartment, remove the old filter, rinse the new one under water, and insert it back before refilling the tank.
Q4. Can the fountain run without a filter?
Yes, but it is not recommended. Using a filter ensures cleaner, fresher water by removing hair, debris, and odors.
Q5. Is the Petwant PWS-112 fountain safe for cats and dogs?
Yes, it is designed for both cats and small to medium-sized dogs. Always keep it filled with fresh water.
Q6. Does the fountain make noise while running?
It runs quietly. If you hear loud noise, check the water level—low water may cause the pump to vibrate.
Q7. What type of power supply does it use?
The fountain is powered by a low-voltage USB adapter, making it energy-efficient and safe for pets.
Q8. How much water can the Petwant PWS-112 hold?
It has a generous capacity (approx. 2 liters), suitable for daily hydration of most cats and small dogs.