Pyle PDWR40W Indoor Outdoor Waterproof Speaker System User Guide

Table of Contents

Pyle PDWR40W Indoor Outdoor Waterproof Speaker System

Remove the bracket knobs and the bracket from the speaker
Hold the bracket up to the mounting surface. “PYLE” can be mounted either horizontally or vertically. Hold the bracket so that the speaker wire fits through the large, circular wire hole in the bracket, and align the bracket to be square with the
surrounding (Use A level for accuracy)
Mark the locations of the three shaped screw holes, use all of the holes
Drill pilot holes into the mounting surface
Gently pull the speaker wire through the wire hole in the center of the mounting bracket, then the bracket so that the holes all line up.
Use your hardware to attach the bracket to the mounting surface

After checking that the speaker is in-phase and works correctly, angle the speaker for the best sound
Hand tighten the bracket knobs only, power tools may over-t ighten the knob, and strip the threads of the insert.
Check that the entire installation is safe and secure..e

PDWR40W/PDWR40B
Excellent for use on Boa and its Marinas.Decks. Patios.Poolside.Outdoors.Etc. Completely Water Proof. Each PDWR40B Features:

Connecting the speakers to your amplifier or receiver.

First, turn your amplifier off to avoid damage that may result from accidental
shorting of the speaker leads.
Correct phase polarity is critical for proper stereo imaging and bass performance.
The red(+) terminal on your amplifier or receiver must be connected to the red (+) terminal on your speaker, the same applies for the black (-) terminal.
Connect one loudspeaker at a time to ensure proper connection of the left and right
channels. Make sure all wires are firmly fastened.
If you notice a high level of bass or central image focus, double-check
connections for proper polarity.

FOR MORE MANUALS BY PYLE, VISIT MANUALSLIBRARYY