SodaStream ART Sparkling Water Maker User Manual

SodaStream ART Sparkling Water Maker

ALL YOU NEED FOR A HANDMADE SPARKLY DRINK

• Sodastream ART™ SPARKLING WATER MAKER
• 1 LITER CARBONATING BOTTLE + CAP
• Sodastream QUICK CONNECT CO2 CYLINDER

GET TO KNOW YOUR ART™

COMPATIBLE WITH THE FOLLOWING ONLY:

• SodaStream reusable Carbonating Bottles
• SodaStream quick connect CO2 cylinder

QUICK CONNECT CO2 CYLINDER

Pull out the carbonating bottle before inserting the CO2 cylinder

1. Remove the plastic cover and pull off the cap
2. Pull open the back cover
3. Raise the pink handle
4. Insert the cylinder, bottom first
5. Lower the handle to lock
6. Replace the back cover

STUFF TO KNOW

Remember – your cylinder is reusable. When it runs out of CO2, simply bring it back and get it exchanged.

PAY ONLY FOR THE CO2 REFILL!

Get an extra cylinder so you never run out of bubbles!

Note: Make sure to exchange the right CO2 cylinder for your sparkling water maker.

SNAP-LOCK SYSTEM BOTTLE INSERT

1. Fill the carbonating bottle with cold water up to the fill line. Always fizz water before adding any flavor.
2. Make sure the bottle rest is tilted out.
3. Insert the bottle neck into the snap-lock. Push it up and then back. The bottle is inserted correctly when there’s a gap between the bottle and the base

DID YOU KNOW?

1 Sodastream reusable bottle can save up to thousands of single-use plastic bottles

THE ART OF FIZZING

1. FIRMLY PUSH the carbonating lever all the way down, HOLD for 1 SECOND, and RELEASE
2. Repeat as desired: 3 times for standard fizz, 5 times for strong fizz
3. Pull the bottle towards you

PRO’S TIP:

Cold water fizzes better. Keep an extra bottle in the fridge, so you always have one ready to sparkle!

SET UP

INSTALLING THE CO2 QUICK CONNECT CYLINDER

1. Place the SodaStream® ArtTM Sparkling Water Maker on a flat, sturdy surface and remove the back cover.
2. Remove the seal and cap from the SodaStream CO2 Quick Connect Cylinder. WARNING! Never insert or replace the CO2 Quick Connect Cylinder while a Carbonating Bottle is installed in the Sparkling Water Maker. This can cause the Carbonating Bottle to be ejected or burst.
3. Raise cylinder Pink Handle. Insert the CO2 Quick Connect Cylinder in the back of the Sparkling Water Maker.
4. Lower cylinder Pink Handle.
5. Reinstall the back cover. Now you are ready to create the bubbles.

SODASTREAM® CO2 QUICK CONNECT CYLINDER

Please note that the SodaStream® ArtTM is only compatible with the C02 Quick Connect Cylinder and is NOT compatible with the SodaStream® CO2 Screw System Cylinder or other cylinders.

COMPATIBLE SODASTREAM® CO2 QUICK CONNECT CYLINDER

NON-COMPATIBLE CO2 SCREW SYSTEM CYLINDER

CREATE THE BUBBLES

1. Fill the Carbonating Bottle with cold water up to the fill line. WARNING! Do not carbonate anything other than water. Other liquids can contaminate and clog internal parts, potentially resulting in excessive pressure, bottle failure during carbonation and serious injury. Never carbonate after flavoring has been added.
2. To insert the Carbonating Bottle, make sure that the Carbonating Bottle’s rest is angled forward. Please make sure you do not pull the carbonating tube. WARNING! Never use a Sparkling Water Maker with a broken carbonating tube. This can cause excessive pressure, bottle failure, and serious injury. Insert the Carbonating Bottle neck into the Snap-Lock. Push the Carbonating Bottle up and back. The Snap-Lock will hold the Carbonating Bottle.
3. To carbonate, push down on the carbonating lever in short 1 second presses; 3 presses for standard carbonation and 5 presses for high.
4. When the desired level of carbonation is achieved, gently pull the Carbonating Bottle towards you until it reaches its fully forward position. This will release the pressure in the Carbonating Bottle and allow the Carbonating Bottle to be released from the Snap-Lock. WARNING! Do not remove the Carbonating Bottle until after hearing the sound of excess CO2 being released. Never force the Carbonating Bottle out of the Snap-Lock. Always allow the Sparkling Water Maker to release the Carbonating Bottle. If the Carbonating Bottle does not immediately release from the Snap-Lock, wait a few moments. If it still does not release, then push the Carbonating Bottle back into the vertical position and gently pull it towards you again. Attempting to remove the Carbonating Bottle while it is still pressurized can cause uncontrolled ejection of the Carbonating Bottle and may result in serious injury.

CARE

SPARKLING WATER MAKER CARE

• Never use abrasive cleaners or sharp tools to clean. If needed, use a mild liquid dish soap and a soft, damp cloth to gently clean.
• Wipe spills to keep the base dry.
• Do not place in water or wash in a dishwasher; doing so will seriously damage your Sparkling Water Maker.

CARBONATING BOTTLE CARE

• For Carbonating Bottles which are not “dishwasher safe”, to clean, rinse Carbonating Bottles with cold or lukewarm water. WARNING! Do not expose to heat above 50°C. Never wash or rinse in hot water. Do not wash in the dishwasher.
• For “dishwasher safe” Carbonating Bottles, to clean, either wash in the dishwasher or rinse Carbonating Bottles with cold or lukewarm water. WARNING! Do not expose to heat above 70°C.

FOR YOUR SAFETY

SAVE THESE INSTRUCTIONS AND PROVIDE THEM TO ANY SUBSEQUENT USERS.

WARNING! Before using the Sparkling Water Maker, to reduce the risk of personal injury and damage to your product, please read this important safety information.

Before allowing anyone to use your Sparkling Water Maker, please be sure they understand how to do so safely. Any servicing or repair should be performed by a SodaStream-authorized service representative. The Sparkling Water Maker is only intended for use by people over the age of 12. People with reduced physical or mental capabilities should only use the product if they are supervised by an adult responsible for their safety, and after they have been given instructions concerning the safe use of the product.

TO REDUCE THE RISK OF EITHER SERIOUS INJURY OR DAMAGE TO THE SPARKLING WATER MAKER DURING CARBONATION:

• Only use your Sparkling Water Maker in its upright position, on a flat, stable surface.
• Do not place your Sparkling Water Maker on a hot surface (e.g., kitchen oven/stove) and never use it close to a flame or leave it in direct sunlight.
• Carbonate water only.
• Do not add flavor before carbonation. Other liquids (except water) can contaminate and clog internal parts, potentially resulting in excessive pressure and bottle failure during carbonation.
• Do not use the machine if the carbonating tube is broken or missing.
• Check that your Carbonating Bottle is properly connected before carbonating.
• Do not move your Sparkling Water Maker or remove the Carbonating Bottle during carbonation.
• Do not carbonate an empty Carbonating Bottle.

CARBON DIOXIDE CO2 CYLINDER

To reduce the risk of a CO2 leak, personal injury, and property damage:

• Do not use any cylinder other than the SodaStream CO2 Quick Connect Cylinder compatible with the ArtTM Pink Handle System.
• Do not insert a CO2 Cylinder into the Sparkling Water Maker when a Carbonating Bottle is installed.
• Do not use if damaged. Inspect the CO2 Cylinder and CO2 Cylinder valve prior to use for dents, punctures, or other damage. If damaged, contact a SodaStream-authorized service representative.
• Do not tamper with the CO2 Cylinder in any way, including puncturing, incinerating, or removing the valve.
• Do not expose the CO2 Cylinder to heat above 50°C. Protect from sunlight. Store in a well-ventilated area.• Do not remove a CO2 Cylinder from the Sparkling Water Maker when it is being operated.
• Do not handle or remove a CO2 Cylinder while it is discharging CO2.
• In the event of a CO2 leak, ventilate the area, breathe fresh air, and if feeling unwell, seek immediate medical attention.

CARBONATING BOTTLE

To reduce the risk of bottle failure, which can result in personal injury and property damage:

• For Carbonating Bottles not marked as “dishwasher safe”, do not expose to heat above 50°C. Never wash or rinse in hot water. Do not wash in the dishwasher.
• For “dishwasher safe” Carbonating Bottles, do not expose to heat above 70°C.
• Do not place the Carbonating Bottle next to a heat source such as your kitchen oven/stove.
• Do not leave the Carbonating Bottle in your car.
• Do not place the Carbonating Bottle in the freezer or in extreme cold below 1°C.
• Do not use the Carbonating Bottle if damaged, deformed, showing changes in shape, scratched, worn, or discolored.
• Do not use a Carbonating Bottle after its expiration date.
• Only carbonate with Carbonating Bottles specifically designed to work with this Sparkling Water Maker, as shown on page 7 above.

CALL US

WE’RE HERE FOR ALL YOUR BUBBLY QUESTIONS:

SODASTREAM.COM

1-800-763-2258

For more Manuals by SodaStream, visit ManualsLibraryy

SodaStream ART Sparkling Water Maker-FAQs