Waykar AFD25D 158 Pints Crawl Space Dehumidifier User Manual

Waykar AFD25D 158 Pints Crawl Space Dehumidifier

SAFETY PRECAUTIONS

• Unplug the power supply cord before cleaning or storing.
• Do not immerse the unit in water or place it close to water.
• Do not put the unit close to heat-generating devices or near flammable and dangerous materials.
• Never put your fingers or any stick-form objects into the air inlet or outlet grilles
• Do not sit or stand on the unit.
• Discard the water collected in the tank as instructed
• Install and run the drainage hose downwards to make sure that condensed water can
• be drained continuously.
• Place and operate the unit on a stable and level floor.

PARTS DESCRIPTION

OPERATION DESCRIPTIONS

Control Panel

Button Instructions

Setting

Power

• When the unit is ON, press [POWER] to enable Standby mode. Then the unit stops working, and the standby indicator turns on.
• When the unit is OFF, press [POWER] to turn on the unit. Then the unit starts working, and  the standby indicator  turns off

Humidity Setting

• When the unit is ON, press [Up] or [Down] to enter the humidity setting. The humidity display %RH flashes and humidity flashes to show the level. Press [Setting] again or wait for a while to exit the settings.
• When setting the humidity, press [Up] or [Down] to adjust the humidity level between 1 and 90% RH (non-cycle setting).
• Press [Up] once to increase 1%RH of the humidity level, while pressing [Down] once to decrease 1%RH of the humidity level. Hold the buttons to continuously increase/decrease the level. When settings finish, press the [Setting] once or wait for a few seconds to exit the humidity setting.

Timer Setting

• If setting up the timer in OFF mode, then it’s the power-on delay. If setting up the timer in ON mode, then it’s the power-off delay. But if the timing hour is 00h, the setting will be invalid. When the dehumidifier is on, press the [Timer] button to enter the timing setting.
• The timer icon lights on, and the numberflashes and shows the remaining working hours. Press [Timer] again or wait for seconds to exit the setting. In the timer setting, press [Up] or [Down] to adjust the timing hours between 00-24 (non-cycle setting). Press [Up] once to increase one hour while decreasing one hour with the button [Down]. Hold the buttons to continuously increase/decrease the hours. When settings are finished, press [Setting] once or wait for a few seconds to exit the timer setting.

Continuous Dehumidifying

• Set up the humidity level at 10% RH, and the unit will enter continuous dehumidifying mode (the icon lights). The dehumidifier is not affected by the humidity level that has been set before. When the unit is OFF, hold the button [Cleaning] to check the cleaning status (the total working time of the dehumidifier). The time will be shown in the timer and humidity displays. Press the ON/OFF button once again or wait for a few seconds to exit the setting.

OPERATION DESCRIPTIONS

Cleaning Setting

Cleaning Time Setting

• When the unit is on, hold the button [Cleaning] to enter the cleaning setting. The icon cleaning lights up, and the number displays the cleaning days.
• Press the button once again, wait for a few seconds to exit the settings
• In the cleaning setting. Press [Up] or [Down] to adjust the cleaning time between 01 and 99 days(non-cycle setting). Press [Up] once to increase 1 day while decreasing 1 day by pressing[Down] once.  Hold the buttons to continuously increase/decrease the days. When settingfinished, press button [Setting] button once or wait for a few seconds to exit the setting.

Check Running Time

• When the unit is OFF, hold the button [Cleaning] to check the cleaning status (the total working time of the dehumidifier). The time will be shown in the timer and humidity displays. Press the ON/OFF button once again or wait for a few seconds to exit the setting.

Reset Running Time

• In the cleaning query mode, press [Setting] once to reset the total cleaning running time(total working time of the fan).

STATUS  DESCRIPTIONS

1. Unit Working Description

• The compressor and fan will stop working successively when the dehumidifier. The compressor will stop working immediately, and the fan will stop working later, whenever the High/Low
• Temperature Protection is triggered, the humidity level set before is reached, and breakdown occurs. Compressor 3 Minutes Delay Protection: After the unit has stopped, it can not be restarted in the first 3  minutes to protect compressor operation. The unit will restart automatically after 3 minutes
• Parameter Memory Function: If the unit stops unexpectedly due to a power cut, it will restart with the previous function setting, such as the cleaning time setting, the Humidity level, or the  PowerOn/OFF status.

2. Indicator Descriptions

• The icon turns off, while the indicator Smart Dehumidifying lights up when turning on the unit.
• The icon lights on, while the indicator Smart Dehumidifying turns off when turning off the unit.
• The icon flashes when the fan starts working, with a time delay; the icon lights on when the fan starts working;  the icon turns off when the fan stops working.
• The icon flashes when the compressor starts working in time delay; the icon lights on when the compressor starts working; the icon turns off when the compressor stops working (Defrost status).
• When the ambient humidity level reaches the humidity level set before, the compressor stops working. Then the icon and the humidity meter flash simultaneously.
• When the cleaning level is reached, the indicator Clean lights up. When the status is dismissed, the indicator turns off.
• When the unit enters high-temperature protection mode, the humidity display flashes and reads
• When the unit enters low-temperature protection mode, the humidity display flashes and reads
• When the unit is in defrost mode, the icon lights up.
• When the unit exits defrost mode, the icon turns off.

3. Error & protection Code

Note

1. If problems were not solved, please unplug the unit and send the unit back for repair.
2. When the unit shows E1, E2, and E4 error codes, it can still work. But some functions are disabled.
   • If the malfunction is still present, please don’t hesitate to contact Waykar Customer Service at support@waykar.com

COMMON FAULTS & SOLUTIONS

• Check the information below for troubleshooting steps, it will save you time resolving issues that may happen with the unit.
• The list includes most of the common cases, but not the results of defective units, crafts, or materials in the unit.
• If all troubleshooting steps have been exhausted and the issue is still occurring, please feel free to reach out to Waykar Customer Service to get further assistance.

SAFETY NOTES

1. 1. When using, please do not put the machine on soft and uneven ground, avoid vibration and movement.
   2. Do not insert thin rods and narrow objects into the machine body to avoid malfunction and danger.
   3. When using, please keep the machine away from heating furnaces, electric kettles, and other heat sources.
   4. When using, please close doors and windows to achieve the best humidity effect.
   5. Please do not put objects around the body. If the ventilation is blocked, the dehumidification effect will be affected
   6. If you do not use the product for a long time, please unplug the power cord
   7. When cleaning the dehumidifier, please use a wet textile to wipe gently; do not shoot the water directly.
   8. When continuous drainage, the drain hose must be placed horizontally, without unevenness and winding.
   9. Please do not put any objects on the dehumidifier.
   10. Please clean the filter every two weeks (do not use hot water above 104°F, alcohol, gasoline, or toluene)

SPECIFICATIONS

• The working temperature of the machine normally ranges from 41°F to 100°F.
• If the room temperature exceeds this range, the machine will not work properly.
  The company reserves the right to change the product, the above parameters are subject to change without notice.

WARNING

• This product can expose you to chemicals including Styrene and its compounds, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to: www.P65Warnings.ca.gov

MAINTENANCE & CLEANING

Maintenance

• Before maintenance and cleaning of the machine, please remove the power plug
• Do NOT clean the machine body with detergent, steel wool, or chemically treated dust cloth, gasoline, benzene, thinner, or other solvents
• Because it will damage the machine’s body.

Clean The Filter

• This machine is equipped with a cleanable filter, which can remove most of the airborne dirt, such as dust, smoke, animal dander, mold spores, and pollen, which reduces allergens in the environment.

Take Out The Filter Net

1. Please use a vacuum cleaner to gently remove the dust from the surface of the filter.
2. If the filter is very dirty, clean it with warm water and mild detergent and dry it completely.
3. Put the filter back in the product

WARRANTY & CONTACT US

Warranty

• Waykar offers a 12-month warranty to all of our products, together with the original proof of purchase, when a defect occurs, including those newly purchased and unused, from Waykar or through an authorized reseller, wholly or substantially, or as a result of faulty manufacturing parts or workmanship during the Warranty Period.
• The warranty does not apply if damage is caused by other factors, including but without limited to:
• (a) Normal wear and tear;
• (b) Abuse, mishandling, accident, or failure to follow operating instructions;
• (c) Exposure to liquid or infiltration of foreign particles;
• (d) Servicing or modification of the product other than by Waykar.
• These are our general terms for the warranty service, but we always encourage our customers to contact us if any issues, regardless of warranty terms. If you are experiencing an issue with the Waykar product, you can reach out to us at support@waykar.com, We will dedicate our efforts to resolving it for you.

For more manuals by WayKar, visit ManualsLibraryy