Ciarra CBPVS01-B Vacuum Sealer Instructions

Ciarra CBPVS01-B Vacuum Sealer

IMPORTANT SAFEGUARDS

Read all instructions before using this appliance.

1.  To reduce the risk of burns, avoid touching the heating strip while using the appliance.
2. To protect against electrical shock or damage, do not place the appliance in water or other liquids.
3. This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities or a lack of experience and knowledge, unless they are supervised or instructed on its use by someone responsible for their safety.
4. Do not place the appliance on or near wet surfaces or heat sources, such as a hot gas or electric burner, or in a heated oven.
5. Please check if the power supply for charging the product is 5V 1A before charging. Do not charge the product if it does not meet these requirements.
6. Please do not use this product if it is damaged. In such cases, the product must be replaced by the manufacturer or a qualified agency to avoid potential safety hazards.
7. If the product becomes too hot or begins to smoke while in use, stop using it immediately. Place it in an open area, wait until the product runs out of power, and then contact the manufacturer’s after-sales service as soon as possible.
8. Vacuum packaging is not a substitute for the heat process of canning. Perishables still need to be refrigerated or frozen.
9. Do not open the appliance lid during operations.
10. Do not immerse the appliance in water or other liquids when cleaning it.
11. This product is equipped with an overcharge protection function. When the battery is fully charged, the charging circuit will automatically reduce the charging current. When the product has low power, the circuit protection will cut off the power to prevent the battery from being completely drained and unable to be charged.
12.  The product switches off automatically after about 3 minutes of inactivity.

POWER CORD INSTRUCTIONS

A short power-supply cord or detachable power-supply cord (shorter than 4 ½ feet or 1.4m) is provided on some models to reduce risks resulting from becoming entangled in or tripping over a longer cord. Longer detachable power-supply cords or extension cords are available and may be used if care is exercised. For models with cords longer than 4 ½ feet (1.4m), or if a long detachable power-supply cord or extension cord is used on short cord models:

• The marked electrical rating of the detachable power-supply cord or extension cord should be no less than the marked electrical rating of the product.
• When the product is of the grounded type, the extension cord must be a grounding-type 3-wire cord.
• The longer cord should be arranged so that it does not drape over the countertop or tabletop where it can be tripped over, snagged, or unintentionally pulled, especially by children.

Precautions:

1. If the vacuum seal bag’s opening is too wide, you can seal it multiple times, as shown in the illustration before vacuuming.
2. Bags with water droplets or oily substances should only be sealed, not vacuum sealed, to prevent water from being sucked into the machine and causing a malfunction.
3. After sealing 3-5 times, it is suggested to rest for a minute to prevent overheating and poor sealing.
4. Before use, please make sure the sealer is dry.
5. It is not recommended to vacuum-seal bags containing liquid.
6. The External extraction mode is only suitable for vacuum canisters and vacuum bags with air valves.

Basic Parameters

What’s included in the box

• 1* Wireless Handheld Vacuum Sealer
• 5* Sealer bags
• 1* External Vacuum Lid
• 1* External Vacuum Hose
• 1* High temperature tape
• 1* USB power-supply cord
• 1* Instruction Manual

Operation Instructions

Before using it for the first time, please charge it for at least 2-3 hours. Failure to do so will reduce the product’s battery life. The charging indicator light remains illuminated when the appliance is plugged in and does not indicate the charge level. When the battery is fully charged, all lights will flash simultaneously.

Note: The unit should be charged for 2-3 hours every 6 months to maintain battery life.

1. Open the upper lid and place the sealed bag flat in the vacuum area within the fixed bracket.
   Note: Leave at least 1.4 inches (35mm) of space between the bag contents and the top of the bag.
2. Close the upper lid. Long-press the power button to start. (Function can be chosen by pressing the power button after the appliance starts.)
3. Lightly press down on both ends. The flashing indicator light indicates the machine is working.
4. The light stops flashing when the operation is complete.
   Note: If the work is complete and the cover cannot be opened, please press the air valve first, then open the cover.

External Vacuum Function

1. Insert one end of the External Vacuum Hose into the air inlet on the appliance. Insert the other end of the External Vacuum Lid into the vacuum bag or vacuum canister. Twist the tab on the External Vacuum Hose while inserting to ensure a tight fit.
2. After connecting, turn on the machine and choose the “Ext” function to start vacuuming. To test the vacuum, simply tug on the External Vacuum Lid. It should not move.

Cleaning and Storage

1. Remove the power cord from the electrical outlet. Do not immerse in liquid. Then open the lowerlid to 90 degrees and remove it for cleaning. Only use the soft cloth to clean the main body.
2. Wash the lower lid in warm, soapy water. Dry thoroughly before re-inserting into the appliance.
3. After the unit has been cleaned, you can store it anywhere for your convenience. The special design of the magnetic bottom make you easily stick it on your refrigerator.

Troubleshooting

Light Display

For more manuals by Ciarra, visit ManualsLibraryy

Ciarra CBPVS01-B Vacuum Sealer-FAQs