Hyper Tough 8100111 Vacuum Cleaner User Manual

Hyper Tough 8100111 Vacuum Cleaner

PRODUCT SPECIFICATIONS

WARNING:
Use only extension cords that are rated for outdoor use. Extension cords in poor condition or that are too small in wire size can pose fire and shock hazards.

To reduce the risk of these hazards when using an extension cord, be sure it is in good condition and that the connection does not come into contact with liquid. To keep power loss to a minimum, use the following table to choose the minimum wire size extension cord.

PACKAGE CONTENTS

SAFETY INFORMATION

IMPORTANT SAFETY INSTRUCTIONS & GROUNDING INSTRUCTIONS
When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE.

ATTENTION!
Read all safety rules carefully before attempting to operate. Retain for future reference.
DANGER!
Never operate this unit when flammable materials or vapors are present because electrical devices produce arcs or sparks that can cause a fire or explosion.
NEVER LEAVE OPERATING VACUUM UNATTENDED!

WARNING!
To reduce the risk of fire, electric shock, or injury:

1. Do not leave the appliance plugged in. Unplug from the outlet when not in use and before servicing. Connect to a properly grounded outlet only. See Grounding Instructions.
2. Do not be exposed to rain. Store indoors.
3. Always disconnect the plug from the wall outlet before removing the tank cover.
4. Do not allow it to be used as a toy. Close attention is necessary when used by or near children.
5. Do not use with a damaged cord or plug. If the appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, contact the service center for assistance.
6. Do not: pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. Do not run the appliance over the cord. Keep cord away from heated surfaces.
7. Do not unplug by pulling on the cord. To unplug, grasp the plug, not the cord.
8. Do not handle the plug or appliance with wet hands.
9. Do not put any object into openings. Do not use with any openings blocked; keep free of dust, lint, hair, and anything that may reduce air flow.
10.  Keep hair, loose clothing, fingers, and all parts of the body away from openings and moving parts.
11. Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
12. Do not use without a dust bag and/or filters in place.
13. Turn off all controls before unplugging.
14. Use extra care when cleaning stairs.
15. Do not use to pick up flammable or combustible liquids such as gasoline or use in areas where they may be present.
16. Do not use your cleaner as a sprayer of flammable liquids such as oil-based paint, lacquers, etc.
17. Do not vacuum toxic, carcinogenic, combustible, or other hazardous materials such as asbestos, arsenic, barium, beryllium, lead, pesticides, or other health-endangering materials.
18. Do not pick up soot, cement, plaster, or drywall dust without a filter and a dust bag in place. These are very fine particles that may affect the performance of the motor or be exhausted back into the air. Additional dust bags are available.
19. Do not leave the cord lying on the floor once you have finished the cleaning job. It can become a tripping hazard.
20. Use special care when emptying heavily loaded tanks.
21.  To avoid spontaneous combustion, empty the tank after each use.
22. The operation of a utility vacuum can result in foreign objects being blown into the eyes, which can result in eye damage. Always wear safety goggles when operating a vacuum.
23. STAY ALERT. Watch what you are doing and use common sense. Do not use a vacuum cleaner when you are tired, distracted, or under the influence of drugs, alcohol, or medication, causing diminished control.
    NOTE: Use only as described in this manual. Use only the manufacturer’s recommended attachments.
    SAVE THESE INSTRUCTIONS
    GROUNDING INSTRUCTIONS
    This appliance must be grounded. If it should malfunction or break down, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This appliance is equipped with a cord having an equipment-grounding conductor and grounding plug. The plug must be inserted into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.
    WARNING!
    IMPROPER CONNECTION OF THE EQUIPMENT GROUNDING CONDUCTOR CAN RESULT IN A RISK OF ELECTRIC SHOCK. CHECK WITH A QUALIFIED ELECTRICIAN OR SERVICE PERSON IF YOU ARE IN DOUBT AS TO WHETHER THE OUTLET IS PROPERLY GROUNDED. DO NOT MODIFY THE PLUG PROVIDED WITH THE APPLIANCE. IF IT WILL NOT FIT THE OUTLET, HAVE A PROPER OUTLET INSTALLED BY A QUALIFIED ELECTRICIAN.
24. This appliance is for use on a nominal 120-volt circuit. The grounded plug looks like the plug illustrated in picture(a). The grounded outlet looks like the outlet illustrated in picture (b). The customer needs to plug the grounded plug into the grounded outlet to accomplish the grounding.
25. No adaptor should be used with this appliance.

OPERATING INSTRUCTIONS

WARNING: To reduce the risk of fire or explosion, do not operate this vacuum in areas with flammable gases, vapors, or explosive dust in the air. Flammable gases or vapors include, but are not limited to, lighter fluid, solvent-type cleaners, oil-based paints, gasoline, alcohol, or aerosol sprays. Explosive dusts include but are not limited to: coal, magnesium, aluminum, and grain or gun powder. Do not vacuum explosive dust, flammable or combustible liquids, or hot ashes. Do not use this vac as a sprayer for any flammable or combustible liquid. To reduce the risk of health hazards from vapors or dusts, do not vacuum toxic materials.

WARNING: The operation of any utility vacuum can result in foreign objects being blown into the eyes, which can result in severe eye damage. Always wear safety eyewear complying with ANSI Z87.1 or in Canada, CSA Z94.3 before starting operation.

CAUTION: To reduce the risk of hearing damage, wear ear protectors when using the vacuum for extended hours or when using it in a noisy area.

This 1-gallon wet/dry vac is assembled at the factory and ready for use when you remove it from the carton. The unit is ready for dry vacuuming. After you plug the power cord into the wall receptacle, turn the unit “ON” by pushing the switch from position “O” to position “I”. The “O” is the “OFF” position, and the “I” is the “ON” position.

DRY PICK-UP

1. The filter must always be in the correct position to reduce the risk of leaks and possible damage to the vacuum. Make sure that the filter is completely covering the filter cage and that the clamp ring is as close to the lid as possible. Make sure there are no gaps between the filter and the lid. (See illustration). It is very important to assemble the filter to the cage without allowing any possible leaks or tears.
2. When using your vacuum to pick up very fine dust, it will be necessary to empty the dust tank and clean or replace the filter at more frequent intervals to maintain peak vacuum performance.

NOTE: A dry filter is necessary to pick up dry material. If you use your vacuum to pick up dust when the filter is wet, the filter will clog quickly and be very difficult to clean. If the filter gets wet, replace it before continuing to do dry pickups.

WET PICK-UP

1. Remove the reusable filter and replace it with a foam filter when you do wet pickups.
2. This wet/dry vac is equipped with a float mechanism that will rise automatically to cut off the airflow when the liquid in the tank reaches a predetermined level. When this happens, turn off the vacuum, unplug the power cord, and empty the dust tank. You will know that the float has shut the airflow off because the suction ceases, and the motor noise becomes higher in pitch due to increased motor speed. The liquid capacity may vary with the rate of pickup.
   IMPORTANT: To reduce the risk of damage to the vacuum, do not run the motor with the float in the raised position.

EMPTY THE TANK

WARNING: To reduce the risk of injury from accidental starting, unplug the power cord before emptying the dust tank.

1. Remove the power head assembly of the wet/dry vac by pulling outward on the lid clips located on each side of the vac. Lift off the power head assembly.
2. Dump the tank contents into the proper waste disposal container.

MOUNTING WALL BRACKET

Mount the wall bracket to a wall stud. Secure with the hardware provided.

NOTE: An inadequately mounted wall bracket could become loose and fall, causing injury or damage to the wet/dry vacuum. The location used to mount the wall bracket should be strong enough to hold the combined weight of the vacuum and accessories.

CARE AND MAINTENANCE

FILTER REPLACEMENT

WARNING: To reduce the risk of injury from accidental starting, unplug the power cord before changing or cleaning the filter.

Your filter should be cleaned often to maintain peak vacuum performance.

IMPORTANT: To avoid damage to the blower wheel and motor, always reinstall the reusable filter before using the vacuum for dry pickups, and always reinstall the foam filter before using the vacuum for wet pickups.

IMPORTANT: After cleaning, check the filter for tears or small holes. Please do not use a filter with holes or tears in it. Even a small hole can cause a lot of dust to come out of your vac. Replace it immediately.
NOTE: Before installing the filter on the vacuum, clean the area of the lid so that the clamp ring will seal the bag against the lid and stop small particles from bypassing the filter bag.

If the filter is clean and not damaged, replace it in the filter cage. If it cannot be reused, place a new filter over the filter cage.

NOTE: Clean the filter in an open area. Cleaning should be done outdoors and not in living quarters.
WARNING: Do not remove the filter cage and float. The float prevents water from entering the impeller and damaging the motor. The cage prevents fingers from touching the moving impeller.

CLEANING

To keep your wet/dry vac looking its best, clean the outside with a cloth dampened with warm water and mild soap.

To clean the tank:

1. Dump out debris.
2. Wash the tank thoroughly with warm water and mild soap.
3. Wipe out with a dry cloth.

STORAGE

Before storing your vacuum, the dust tank should be emptied and cleaned. The cord should be wrapped and hung on the unit, and the accessories should be kept in the accessory holder so they can be readily available. The vac should be stored indoors.

TROUBLESHOOTING

WARNING!

TO REDUCE THE RISK OF INJURY FROM MOVING PARTS AND/OR ELECTRICAL SHOCK, TURN THE POWER SWITCH OFF AND DISCONNECT THE GROUNDED PLUG FROM THE ELECTRICAL OUTLET BEFORE PERFORMING TROUBLESHOOTING CHECKS.

Minor problems often can be fixed without calling customer service.

EXPLODED VIEW / PARTS LIST

Alton Industry Ltd. Group

2-year Limited Warranty

This warranty covers any defects in materials or workmanship of the enclosed product. Alton Industry Ltd. Group will repair or replace any defective materials due to the craftsmanship of the product. This warranty does not cover any problem caused by misuse, abuse, accidents, or acts of God, such as floods or hurricanes. Consequential and incidental damages are not covered under this warranty. Coverage terminates if you sell or otherwise transfer the ownership. If you feel you have a defective product, please submit a copy of your receipt to the address below and call 1-888-899-0146 for instructions prior to returning this item to the store or sending it back to: Alton Industry Ltd. Group 1031 North Raddant Rd Batavia, Illinois 60510

We will inspect the product and contact you within 72 hours to give you the results of our inspection. We reserve the right to repair or replace the product at our discretion. However, we may replace the product with one of similar but not exact features. Parts and Service Information available, call Alton Industry at 1-888-899-0146. This warranty gives you specific legal rights. You may have other rights that vary from state to state.

For more manuals by Hyper Tough, visit ManualsLibraryy

Hyper Tough 8100111 Vacuum Cleaner-FAQs