Ingenuity AnyWay Sway PowerAdapt Dual-Direction Swing User Manual

Ingenuity AnyWay Sway PowerAdapt Dual-Direction Swing

IMPORTANT

• The provided USB cord is 183cm in length
• Please read all instructions before assembly and use of the product.
• Care should be taken in unpacking and assembly.
• Examine product frequently for damaged, missing, or loose parts
• DO NOT use if any parts are missing, damaged, or broken.
• Contact Kids2 for replacement parts and instructions if needed. Never substitute parts
• This product does not replace a cot or a bed. Should your child need to sleep, then it should be placed in a suitable cot or bed.

Battery Information

• The swing control module requires (4) size C/LR14 (1.5V) alkaline batteries (not included). The vibration unit requires (1) size C/LR14 (1.5V) alkaline batteries (not included).
• CAUTION: Follow the battery guidelines in this section. Otherwise, battery life may be shortened or the batteries may leak or rupture.
• Always keep batteries away from children.
• Do not mix old and new batteries.
• Do not mix alkaline, standard, or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Install the batteries so that the polarity of each one matches the markings in the battery compartment.
• Do not short-circuit the batteries.
• Do not store batteries in areas that have extreme temperatures (such as attics, garages, or automobiles).
• Remove exhausted batteries from the battery compartment.
• Never attempt to recharge a battery unless it is specifically marked “rechargeable.”
• Rechargeable batteries are to be removed from the toy before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Please use the correct disposal method for batteries.
• Remove batteries before putting the swing into storage for a prolonged period of time.
• Weak batteries cause erratic product operation, including distorted sound, dimming or failed lights, and slow or non-working motorized parts. Because each electrical component requires a different operating voltage, replace the batteries when any function fails to operate.
• Do not dispose of product or batteries in fire, batteries may explode or leak.

Care and Cleaning

• Seat pad – Remove from frame. Fasten buckles on seat restraint and seat pad. Fasten all hook-and-loop patches to the corresponding patch. Machine wash with cold water, gentle cycle. No bleach. Tumble dry, using low heat.
• Headrest – Fasten all hook-and-loop patches. Machine wash with cold water, gentle cycle. No bleach. Air dry flat.
• Toy bar and toys – Wipe clean with a damp cloth and mild soap. Air dry. Do not immerse in water.
• Frame – Wipe the metal frame with a soft, clean cloth and mild soap.
• Storage – When putting swing away for storage, always store in a dry location, away from any heat sources, and out of the sun.

Not included

Using in the Seat Mode

Using the Seat Restraint

Using the Recline Function

Rotation of the seat

Storage and Travel

Removing the seat pad for cleaning

Using the Swing Control Module

• Touch the Power switch to power the Swing Control Module.
• The Speed Selector function provides 6 speed settings and OFF. The LEDs operate sequentially and in bar graph mode. To start the swing function, touch the button until the flashing LED bar graph displays the desired setting. When you change the speed setting during swing motion, the LED bar graph will flash for five seconds during the speed adjustment. When the swing timer expires, the swing stops and the Speed Selector and Timer LEDs turn OFF
• Use the Swing Timer Select function to turn OFF the swing automatically. Touch the button to sequence to the desired timer setting of 15, 30, or 60 minutes. The three LEDs above the button indicate the selected time period. If you do not select a timer setting (all LEDs are OFF), the unit uses a default time of 2 hours for auto-shutoff. To use the swing function after auto-shutoff, either OK, press the Swing Timer Select button or the Speed Selector button
• Touch the Nature Sounds/Music button to begin music and nature sounds playback. Touch as needed to select the desired nature sound or song. Auto-shutoff occurs after about 20 minutes.
• Touch the Volume Control switch as needed to turn off or adjust the volume for music and nature sounds.

For more manuals by Ingenuity, visit ManualsLibraryy

Ingenuity AnyWay Sway PowerAdapt Dual-Direction Swing-FAQs