ROSEKM KC-KM13T Filterless Cool Mist Ultrasonic Humidifier
PACKAGE CONTENT
Saftey instructions
To reduce the risk of fire, electric shock, or other injury, follow all instructions and safety guidelines.
General Safety
- Disassembly, repair or remodeling by an unauthorized person may result in serious harm and will void the manufacturer’s warranty.
- If the humidifier is damaged or is not functioning properly, stop using it and contact Customer Support immediately.
- Please always keep the humidifier out of reach of children &pet.
- Do not use the humidifier in wet environments. * Always place the unit 12 inches (30 cm) away from the wall and other appliances.
- Do not handle the plug with wet hands.
- Please check the cord for any signs of damage. DO NOT use the humidifier if the cord has been damaged.
- Do not cover or remove the nozzle while using the humidifier.
- Do not move or tilt the humidifier while it is in operation.
- Do not fill the water tank with hot or boiling water.
- Do not use this product in direct sunlight or near a heat source such as a stove, heater, or radiator.
- Use clean or distilled water in the tank. Hard water areas will require more frequent cleaning.
SPECIFICATIONS
PRODUCT DIAGRAM
- Nozzle
- Tank Cover
- Handle
- Water Tank
- Mist Tube
- Water Inlet
- Tank Cap
- Base
- Indicator
- 10. Timer Button
- Power Button
- Air Outlet
- Base Chamber
- Atomizer
- Floater
- Air Inlet
FUNCTIONS
Power On/Off & Mist Level Setting
- plug in the humid
- Press
repeatedly to cycle through missed settings COV OH OF - After turning off the humidifier humidor Immaculata stopped producing, and the fan will sleep for a minute
- When your oom has reached a comfortable humid level, your humidifier ta lower singer ur off, Uncomfortable humidity is viewed over 40% and below 60%
repeatedly to cycle through missed settings COV OH OFTimer
Press
cycle through the options of 1 hour, 2 hours, 4 hours, and 8 hours to shut off the humidifier, or turn off the timer.
360° Nozzle
easily direct the flow of mist
AutoDimindicator
The indicator will run the hide sn operated within 10 seconds.
Auto Shutoff
When the humidifier runs out of water, it would stop producing and the victor will kee Tain. Designed or safe in case the humidor is overhead.
GETTING STARTED
- Turn the water tank upside down and remove the tank cap.
- Fill the tank with clean and cool water only.
- Attach the tank cap.
- Turn the tank over to place on the humidifier base.
- Plug in the humidifier.
- Press the power button to turn on the humidifier.
IMPORTANT TIPS
- Do not add water through the mist tube, otherwise water may enter the air outlet and damage the electrical components.
- Please always place this humidifier on a firm, flat & and water-resistant surface at least 2-4 feet above the floor. Placing a humidifier in a corner, on the floor, or near a wall will get localized higher humidity levels, but the rest of the room will still feel dry.
- It is not recommended to place this humidifier directly on wood furniture or the floor, because the locally high humidity levels may wet the surroundings. Please put a tray underneath the humidifier if you place the humidifier on a non-waterproof surface.
- Do not add essential oils to the water tank or base chamber. Essential oils will corrode the humidifier, causing the water tank or base to crack.
- Place this product on a cloth or carpet that may block the air inlet. Attention to whether the mist output of the humidifier is affected if you do that.
GETTING STARTED
- You should clean your humidifier every week and when you’re ready to store
- All maintenance should be done on a water-resistant surface such as a kitchen counter.
- Change the water frequently to avoid bacterial growth
- If not use the humidifier for 3 days or longer. Do not leave water inside. Clean and dry the humidifier instead.
- Distilled or purified water is recommended to fill the humidifier. In some areas, water is richer in minerals. The humidifier won’t
instantly go haywire if you do use tap water. But in the long term will cause scale, and you need to maintain it more often.
CAUTION
- Never immerse the humidifier base in water.
- Please avoid the water into the air outlet and air inlet while cleaning or filling water, which will damage the electrical components.
Cleaning & Descaling
- Turn off and unplug the humidifier.
- Remove the water tank from the base and remove the tank cap. Drain water from the water tank and base.
- Fill the tank with 2 US cups /474 mL of distilled white vinegar. Replace the tank cover and swish the vinegar around the tank.
- Place the tank on the base. The vinegar solution will enter the base chamber to loosen mineral buildup (scale) on the atomizer and the bottom of the water tank. Soak for 15-20 minutes.
Remove the water tank and tank cover, pour out any solution. Clean the atomizer with a soft cloth or cotton swab to remove loosened mineral deposits. (The mist tube or corners that are out of reach can be cleaned with the included brush)
Rinse all parts until any vinegar smell is completely gone before resembling.
Caution
When putting the tank cover back onto the top of the humidifier, in order to tightly seal the tank cover, the edge of the cover with the arrow should be aligned with the direction indicated by the arrow on the top of the humidifier. Otherwise, mist may escape from the gaps during the working of the humidifier.
Troubleshooting
Problem | Possible Cause |
Indicator flashes. | Not enough water inside the base chamber. Fill the water tank.
|
Ensure the 1 spring is secured properly to the tank allowing water to pass through to the base. | |
3 The water floater gets stuck. Adjust the water float to a horizontal position and make sure it can rise up with water. | |
Water leaks from | Tighten the water tank cap. |
The 2 rubber ring was not installed on the tank cap. | |
Leak from TANK: Check for possible cracks in | |
Leak from BASE: Contact Customer Support |
Problem | Possible Cause |
A humidifier doesn’t | Ensure the unit is properly plugged into a power outlet / try another power outlet.
|
Humidity level is | Turn the mist level to a higher setting. |
Mineral buildup on the atomizer. Clean atomizer | |
Make sure the air inlet on the bottom of the base is not blocked. The humidifier should not be set on carpet or other surfaces that may block the air inlet. | |
Make sure the nozzle is not blocked or clogged. | |
Make sure the humidifier is on a level surface. | |
The water in the unit is too cold: Replace with cool water. | |
Condensation | Saturation of humidity: Lower mist control
|
Point the mist away from objects: Raise unit on a | |
Mold grows inside the humidifier, or white dust appears around the humidifier. | Use purified or distilled water to fill the |
Clean the humidifier (see Cleaning & Descaling, | |
Humidifier |
Clean the water tank and base chamber (see |
The humidifier makes | Bubbling or knocking sounds are normal, that is |
If it is continuous motor noise, the humidifier |
WARRANTY
This humidifier comes with a 1-Year Warranty that begins on the date of purchase. Rosekm will replace any product found to be defective due to manufacturer flaws, based on eligibility. This warranty is void if the defect is due to any damages, losses, or inconveniences caused by equipment failure by user negligence, abuse, or use noncompliant with the user manual or any additional safety, use, or warnings included in the product packaging and manual.
CUSTOMER SUPPORT
If you encounter any issues or have any questions regarding your new product, feel free to contact our helpful Customer Support Team.join Us: support@rosekm.net
Please have your order ID ready before contacting Customer Support.
For more manuals, Rosekm, visit ManualsLibraryy
ROSEKM KC-KM13T Filterless Cool Mist Ultrasonic Humidifier-FAQs
Why isn’t my ROSEKM humidifier working properly?
Check if the nozzle is blocked, if the unit is placed on a flat surface, and if the water temperature is too cold. Also, reduce the mist level if the air is already very humid.
How can I tell if my cool mist humidifier is working?
Set the mist output to high and place a paper or moisture indicator nearby. If the paper stays dry after several hours, the unit might not be functioning.
Why does the humidifier shut off even when it’s full of water?
This could be due to mineral buildup on the heating element, causing it to overheat and shut down. Cleaning the element regularly can help prevent this.
How does a cool mist humidifier work without using heat?
It uses either ultrasonic vibrations to turn water into fine mist or a fan with a wick to evaporate water—raising humidity without changing the room temperature.
Can a humidifier work without a filter?
Some models, like the ROSEKM KC-KM13T, are filterless and still effectively increase moisture levels using ultrasonic technology.
What does a mist filter do?
In photography, mist filters diffuse light to soften images. In humidifiers, filters help remove impurities, but the ROSEKM model operates efficiently without one.
Are cool mist humidifiers safe to use?
Yes, but they must be kept clean. A dirty humidifier can release bacteria or mold into the air, potentially worsening allergies or asthma.
Is a humidifier the same as a nebulizer?
No. A humidifier increases moisture in the air, while a nebulizer is a medical device used to deliver medications directly to the lungs.