SHARP SPC033 Digital Clock with Alarm User Guide

SHARP SPC033 Digital Clock with Alarm

Table of Contents

FEATURES

Large 1.8″ LED Display
High or Low Alarm Volume
High or Low Display Brightness
9 Minute Snooze • Case Swivels 90°
Optional Battery Back-up (Requires One 9-Volt Battery (Not Included))

POWER SUPPLY

Begin by plugging in the power cord into a standard household outlet. The display will flash, indicating the clock needs to be set.

SETTING THE CLOCK

While holding down the TIME button, press the HOUR button to advance to the correct hour. The PM indicator will light when the hour is advanced into the PM time.
While holding down the TIME button, press the MIN button to advance to the correct minute.
Release the TIME button when the correct time is shown on the display.
When setting the time, be sure you are in the correct AM or PM time as indicated by the PM light on the display.

SETTING THE ALARM

While holding down the ALARM button, press the HOUR button to advance to the correct hour. The PM indicator will light when the hour is advanced into the PM time.
While holding down the ALARM button, press the MIN button to advance to the correct minute.
Release the ALARM button when the correct alarm time is shown on the display. To verify your alarm time setting, press and hold the ALARM button, and the alarm time will appear on the display.
When setting the alarm time, be sure you are in the correct AM or PM time as indicated by the PM light on the display.

USING THE ALARM

To activate the ALARM, pull the ALARM ON/OFF switch to raise it into the ON position. The ALARM ON indicator will light, and the alarm will sound at the preset time.
To silence the ALARM, press the ALARM ON/OFF switch into the OFF position

SETTING THE ALARM VOLUME

Slide the ALARM VOLUME switch to either HIGH or LOW volume.

USING THE SNOOZE

To use the Snooze, press down on the SNOOZE BAR when the alarm is sounding. The alarm will be silent temporarily, but will resume sounding after 9 minutes. This can be repeated as often as you wish for up to one hour.

USING THE DIMMER

Slide the DIMMER switch to either the HIGH or LOW setting to control the brightness of the clock display.

USING THE BATTERY BACKUP

Insert one 9V battery into the battery compartment on the underside of the clock. The battery will hold the ALARM and TIME settings until power is restored. The alarm will sound at the selected time, only the display will not light to save battery power.

BATTERY CAUTION

Only batteries of the same or equivalent type as recommended are to be used.
Batteries are to be inserted with the correct polarity.
The supply terminals are not to be short-circuited.
Do not dispose of batteries in the fire; batteries may explode or leak.
An adult assembly is required to replace and remove the battery.

CARE OF YOUR CLOCK

Store the clock without a battery when not in use. A soft cloth or a paper towel may be used to clean your clock. Do not use any corrosive cleanser or chemical solutions on the clock. Keep the clock clean and dry to avoid any problems.

If customer service is needed, please email custserv_clocks@mzb.com or call toll-free at 1-800-221-0131 and ask for Customer Service.

Monday-Friday 9:00 AM – 4:00 PM EST

One-Year Limited Warranty

M.Z. Berger & Company warrants the original consumer purchaser of this product that it shall be free of defects in materials and workmanship for one year from the purchase date of this product. Defects caused by tampering, improper use, unauthorized modifications or repairs, water immersion, or abuse are not covered by this warranty. If a defect covered by this warranty occurs during the warranty period, wrap your clock carefully and send it to the following address:

M.Z. Berger & Co., Inc. 353 Lexington Ave – 14th Fl. New York, NY 10016

You must include a Proof of Purchase, either the original receipt or a photocopy, and a check or money order for USD 6.00 to cover the cost of handling. Also, include your return address inside the package. M.Z. Berger will repair or replace the clock and return it to you. M.Z. Berger will not be liable for any loss or damage, including incidental or consequential damages of any kind, from any breach of warranty, either expressed or implied, relating to the product. Since some states do not allow the exclusion or limitation of incidental or consequential damages, this limitation may not apply to you.

Instructions

Read Instructions- All the safety and operating instructions should be read before the appliance is operated.
Retain Instructions – The safety and operating instructions should be retained for future reference.
Heed Warnings – All warnings on the appliance and in the operating instructions should be adhered to.
Follow Instructions – All operating and use instructions should be followed.
Water and Moisture – The appliance should not be used near water – for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, and the like.
Carts and Stands – The appliance should be used only with a cart or stand that is recommended by the manufacturer.
- An appliance and cart combination should be moved with care. Quick stops, excessive force, and uneven surfaces may cause the appliance and cart combination to overturn.
Wall or Ceiling Mounting – The appliance should be mounted to a wall or ceiling only as recommended by the manufacturer.
Ventilation – The appliance should be situated so that its location or position does not interfere with its proper ventilation, For example, the appliance should not be situated on a bed, sofa, rug, or similar surface that may block the ventilation openings, or, placed in a built-in installation, such as a bookcase or cabinet that may impede the flow of air through the ventilation openings.
Heat – The appliance should be situated away from heat sources such as radiators, heat registers, stoves, or other appliances (including amplifiers) that produce heat.
Power Sources- The appliance should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance.
Grounding or Polarization – The precaution should be taken so that the grounding or polarization means of an appliance is not defeated.
Power-Cord Protection – Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance.
Cleaning – The appliance should be cleaned only as recommended by the manufacturer.
Nonuse Periods – The power cord of the appliance should be unplugged from the outlet when left unused for a long period.
Object and Liquid Entry – Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings.
Damage Requiring Service – The appliance should be serviced by qualified service personnel when:
- The power supply cord or the plug has been damaged; or
- Objects have fallen, or liquid has been spilled into the appliance; or
- The appliance has been exposed to rain, or
- The appliance does not appear to operate normally or exhibits a marked change in performance; or
- The appliance has been dropped, or the enclosure has been damaged.
Servicing – The user should not attempt to service the appliance beyond that described in the operating instructions. All other servicing should be referred to qualified service personnel.

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Digital Alarm Clock

CAUTION

RISK OF ELECTRIC SHOCK. DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (ON BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightning flash and arrowhead within the triangle are a warning sign alerting you of “dangerous voltage” inside the product.

The exclamation point within the triangle is a warning sign alerting you to important instructions accompanying the product.

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION: TO PREVENT ELECTRIC SHOCK, DO NOT USE THIS (POLARIZED) PLUG WITH AN EXTENSION CORD, RECEPTACLE, OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.

Please read this before operating your unit.

For more manuals by SHARP, visit ManualsLibrary

SHARP SPC033 Digital Clock with Alarm User Guide